Examples of 're-tighten' in a sentence
Meaning of "re-tighten"
Re-tighten (verb) - The action of tightening something again that was previously tightened but may have become loose
How to use "re-tighten" in a sentence
Basic
Advanced
re-tighten
Re-tighten mounting screws on any loose part.
Rotate to appropriate angle and re-tighten fasteners.
Re-tighten the screw to secure the wheel guard.
At each inspection re-tighten the anode attaching bolt.
Re-tighten the bolts to secure the caster in position.
Contact your service partner to re-tighten the screws.
Re-tighten the screw in a clockwise direction.
If there are any leaks carefully re-tighten all connections.
Re-tighten all screws in the hanging bracket or plate.
Periodically check and re-tighten as needed.
Re-tighten fastening button counter clockwise.
Close main gas supply and re-tighten all connections.
Re-tighten the srew as soon as they begin to move.
Check for leaks and re-tighten assembled parts if leaks appear.
Re-tighten all connections on contactors and any circuit breakers.
See also
Adjust the seat and re-tighten the seat fixing bolt.
Re-tighten all wiring terminal connections to specified torque values.
Flush the valve by temporarily opening the dump hole and re-tighten.
Re-tighten the screws before closing the door to test.
Untighten these screws with a suitable screwdriver and re-tighten them again.
Re-tighten the knobs once the desired height is reached.
Maintain pressure on the receiver and re-tighten two of the hex bolts c.
Re-tighten the lock not after adjusting the tension.
Set fence guide to desired angle and re-tighten the two bolts.
Re-tighten the bolted connection firmly with your hand.
Remove the armrest assembly and re-tighten the remaining two hex boltsc.
Re-tighten the axles after changing over the wheels.
Move the back tubes to the desired position and re-tighten all screws.
Re-tighten both the adjustment nut and mount lock bolt.
It is highly recommended to regularly check and re-tighten the terminal screws over time.
Be sure to re-tighten the table support lock handle before drilling.
Periodically inspect the tightness of all screws and re-tighten any that are loose.
Re-tighten the terminal screws on the garage door opener and.
The slide to the desired rebating width and re-tighten the wing nut.
Re-tighten and check all electrical connections in the extension cables.
After setting to the desired position, re-tighten the screws see the page on torque.
Re-tighten the tilt knobs to lock the tilt angle in place.
Once the proper tension is reached, re-tighten the upper nut to secure the cable.
Re-tighten the screw once the desired position has been obtained.
To do this release the screws, move the spacer bracket and re-tighten the screws.
Be sure to re-tighten the front jacket panel to the heat pump.
Rotate the handle to the desired position and turn the handle grip clockwise to re-tighten.
Re-tighten the high gear adjusting screw until it meets resistance.
When proper adjustment is achieved, re-tighten the outer nut and replace the end cap.
Re-tighten the chain tensioner bolt by turning the chain tensioner bolt.
After you have finished all adjustments, snugly re-tighten the screws that have been loosened.
Re-tighten nut until there is just enough tension to permit smooth operation.
Drain the oil from the oil tank and re-tighten the oil drain plug.
Loosen and re-tighten the screws in the height adjustment slots as necessary.
With rubber tighteners, it means you will not have to stop and re-tighten after installation.
