Examples of 'reaction tubes' in a sentence
Meaning of "reaction tubes"
Reaction tubes are small cylindrical containers used in laboratories to perform chemical reactions. They are usually made of glass or plastic and are designed to withstand the heat and pressure generated during the reaction. Reaction tubes allow scientists to mix and observe the results of chemical reactions in a controlled environment
How to use "reaction tubes" in a sentence
Basic
Advanced
reaction tubes
Open caps of reaction tubes in the aluminum block.
Seven microliters of each mixture was transferred to final reaction tubes.
The ends of the reaction tubes open into liquid chambers.
Each insert tube is preferably centered within the reaction tubes.
Two liquid phases moving down reaction tubes would perform inefficiently.
Reaction tubes are placed on ice in preparation for the manipulations that follow.
The kit may further comprise a number of reaction tubes or a microplate.
Never open reaction tubes after amplification has started under any circumstances.
The reaction mixture is prepared and distributed into said reaction tubes.
The number of reaction tubes will depend on the amount of heat transfer desired.
Fluorescent product were also observed by direct visualization of the reaction tubes on a transilluminator.
Most of reaction tubes disposed in the shell are connected with the baffle plates.
It is preferred that the one or more reaction tubes also comprise the beads.
Aliquots of this test solution are then placed into three separate reaction tubes.
Keep all Reaction Tubes closed at this time.
See also
The alumina balls were further packed thereon to upper portions of the reaction tubes.
The method of claim 1 wherein reaction tubes are cooled with water.
It is understood that the methods disclosed herein can comprise multiple reaction tubes.
What are the maximum speeds at which reaction tubes can be centrifuged?
This estimation is performed as described above for in situ PCR performed in reaction tubes.
Place the required number of Assurance GDS reaction tubes in the aluminum block.
The reaction tubes are preferably made of a dielectric material, for example glas.
And well contents transferred to Eppendorf reaction tubes.
A process according to claim 8 wherein the reaction tubes contain an endothermic reaction catalyst.
A thermocycler currently available uses a heat block capable of holding up to 48 reaction tubes.
Accordingly, the inner diameters of the reaction tubes are very important.
Therefore, it is very important to pack the catalyst uniformly in the respective reaction tubes.
In another preferred embodiment, one or both reaction tubes further comprise internal controls.
In other embodiments, the multiplex method takes place in separate reaction tubes.
Packing the catalyst in the reaction tubes of the fixed bed multi-tube reactor.
In certain embodiments, a plurality of small diameter reaction tubes can be used.
Thin-walled reaction tubes permit favorable thermal conductivity to allow for rapid thermal equilibration.
The method of claim 1 wherein the reaction tubes are cooled.
The reaction tubes are allowed to stand at room temperature for 30 minutes.
In certain cases, a plurality of small diameter reaction tubes can be used.
Namely, peak temperatures inside the reaction tubes are preferably grasped for predicting the reaction states.
Highly preferably, the formation of flames in contact with the reaction tubes is avoided.
All buffers, lysates and reaction tubes were pre-cooled on ice.
Eight microliters of the RNA-primer mixture was added to the final reaction tubes.
For each sample, a total of 5 reaction tubes were prepared.
Beads were again washed 3 times with distilled water and transferred to clean reaction tubes.
The reaction tubes are hand-carried to a stand-alone plate reader for detection.
In such a case, the packing specifications of the catalyst in the reaction tubes are changed.
The reaction tubes 76 are respectively surrounded by a cooling liquid channel 78 for cooling of the tubes.
Multi-point thermocouples were provided to allow measurement of catalyst layer temperature in the reaction tubes.
Incubations are performed in polypropylene reaction tubes in a 37 °C water bath.
This permits camera 16a to receive the fluorescence signals emitted from within the amplification reaction tubes.
Magnesium oxalate / butyral resin-coated reaction tubes were prepared as described in Example 1.
The method of claim 1 wherein a ballast gas is additionally introduced into the reaction tubes.
All reaction tubes were incubated at 37°C for one hour and then placed on ice.
You'll also be interested in:
Examples of using Tubes
Show more
With tubes running directly to her uterus
Flood torpedo tubes one and two
Feed tubes down through the hole in
Examples of using Reaction
Show more
It would give its reaction at a later date
Quick reaction times in case of delay s or malfunctioning
I am having a physical reaction to how bad this is
