Examples of 'receiver battery' in a sentence
Meaning of "receiver battery"
A receiver battery refers to a rechargeable battery that is used to power electronic devices such as remote controls or portable radios. It is designed to receive and store electrical energy from a charger and then supply it to the device when needed.
How to use "receiver battery" in a sentence
Basic
Advanced
receiver battery
If your receiver battery runs out of power.
Let us start with the receiver battery.
Receiver battery is not completely charged.
Tool needed for receiver battery installation.
Disconnect the transmitter and the receiver battery.
Plug of the receiver battery is loose.
Wireless switch equipped with a power circuitry that allows direct connection to receiver battery.
Installing the receiver battery and switch harness.
Check the state of the transmitter and receiver battery charges.
Connect the receiver battery to any of the other ports.
Replacing the collar receiver battery.
Check receiver battery indication to ensure that batteries are providing power.
Fully charge the audio receiver battery before first use.
The receiver battery must be charged before every flying session.
It is vital to check the state of the receiver battery at regular intervals.
See also
Secure the receiver battery in the fuselage using hook and loop tape.
The charge level of the headset receiver battery may be too low.
If the receiver battery runs down it will remain in the last operating position.
Power the receiver by plugging in a receiver battery in any port on the receiver.
Check Receiver battery to make sure it is installed properly.
Foam padding for the receiver and receiver battery are included in the kit.
Secure the receiver battery in the fuselage using a hook and loop strap.
The receiver stops responding during operation Low receiver battery voltage.
The location of the receiver battery can be changed to correctly balance your model.
An alternative method of balancing is to re-position the receiver battery further forward or aft.
Receiver battery capacity is low Charge the receiver battery.
Check the transmitter and receiver battery charge Insert fully charged batteries.
Telemetry facilities with appropriate receiver display / monitor of receiver battery voltage.
A separate receiver battery is not required if you fit the recommended BEC electronic speed controller.
Check the battery voltage of the transmitter, ignition module and receiver battery.
Insert the receiver battery into ANY open port.
Electrical ignition systems should always be powered by a separate battery - not the receiver battery.
Receiver battery life Fully charged battery up to 9 hours.
The servo remains in the fail-safe position, even if the receiver battery recovers slightly.
Receiver battery number of cells, capacity, cell type, state of charge.
If necessary, adjust the position of the receiver battery to correct the CG position.
The current receiver battery voltage is also shown in the basic display ; see page 24.
Use the template on page 66 of the manual to make the receiver battery tray.
Model type symbols Model memory number Receiver battery voltage telemetry-capable receivers only.
Slide the receiver battery 3.2 into place, running the cable out of the wing.
Distortion, - The charge level of the headset receiver battery may be too low.
Connect the 6 V receiver battery ( hump rechargeable battery pack ) to.
When the LED 18 is illuminated Green, the receiver battery is fully charged.
Note, To use battery power, refer to the Receiver Battery Installation section.
You'll also be interested in:
Examples of using Battery
Show more
The battery icon flashes during charging
Danger of explosion if the battery is incorrectly replaced
The battery pack is probably completely empty
Examples of using Receiver
Show more
Occupiers refuse receiver entry into shipyard
Receiver unit is outside the maximum range
Make sure that the receiver is turned on
