Examples of 'remove the connector' in a sentence
Meaning of "remove the connector"
To remove the connector means to detach or disconnect a connector from its corresponding socket or interface. It is often used in the context of electronic devices or wiring systems where connectors are used to establish electrical or mechanical connections. Removing the connector is necessary for tasks such as maintenance, repair, or replacement of components or for disassembling a system or device
How to use "remove the connector" in a sentence
Basic
Advanced
remove the connector
Do not pull the cable to remove the connector.
Remove the connector and open the bag door.
Keep the screws for later and remove the connector plate.
Remove the connector panel if a different panel is to be installed here.
Do not pull by the wiring or use any tools to remove the connector.
Remove the connector valve by unscrewing the coupling nut.
Pull the locking collar down to remove the connector from the faucet.
Remove the connector on the end of the new cuff.
Use a wrench to loosen and remove the connector from the feed tube.
Remove the connector cover at the rear of the printer.
Press the tab on the bulb socket and remove the connector cord.
Remove the connector cover prior to plugging in your audio source.
Continue gently pulling back to remove the connector from the aircraft control panel.
Remove the connector with the bulb by pulling it back in the direction of the.
Loosen the four screws at the rear of the projector to remove the connector panel.
See also
Do not remove the connector until all gear is switched off.
Loosen the ten screws at the rear of the projector to remove the connector panel.
Carefully remove the connector from the lamp assembly in the direction of.
Press down on the thumb release and remove the connector from the faucet.
Remove the connector with the bulb by jiggling it out in the direction of the.
Select Remove connector to remove the connector from the system.
Remove the connector from the valve when the water stops flowing.
To start a new summation, remove the connector by deleting it.
Remove the connector or power wires and test them using a multimeter set to ohmmeter.
I can't help with how to remove the connector.
Remove the connector from the mask by pressing the side buttons and pulling it away.
To use the connector, remove the connector cover as follows.
Remove the connector from the fan and the ignition unit from the gas valve.
When disconnecting the direct interface cable, remove the connector by pressing both sides.
Remove the connector from the end of the UV lamp.
Press the locking mechanism 4 and remove the connector 2.
Gently pull back to remove the connector from the aircraft control panel.
Fold the wheel house trim to the side, remove the connector 1.
Cut the clip Remove the connector from protective sleeve.
Disconnect the connector ( A ) from the evaporator temperature sensor, then remove the connector clip ( B ).
Do not remove the connector linking terminals PO and PA.
If necessary, remove the connector using the red handle.
Remove the connector to the bulb in the direction of arrow 2.
If necessary, remove the connector with the red handle.
Remove the connector holding collars, and both link boards.
Carefully remove the connector from the tail lamp assembly in the direction of the arrow 3.
Remove the connector from the bulb, unlock the securing clip and remove the.
Remove the connector ( diode-bridge ) from the top of the water pump.
Remove the connector on the bulb, unlock the circlip, and remove the light.
Remove the connector plug on the S8 Elite before you attach the HumidAire 3i.
Remove the connector ( b ) and then.
Remove the connector from the bulb, unlock the securing clip and remove the bulb » Fig . 158.
You'll also be interested in:
Examples of using Connector
Show more
Only the appropriate connector must be used
Purple connector for black whip antenna
Plug the charger connector into the
Examples of using Remove
Show more
You agreed to remove two thousand troops
Remove the battery cover by sliding it downward
Never disable or remove the contact arm
