Examples of 'resistance values' in a sentence
Meaning of "resistance values"
Resistance values refer to the measure of resistance exhibited by a substance or material to the flow of electric current. It is typically represented in ohms (Ω) and is a crucial parameter in electrical and electronic circuits. Resistance values determine how much a component or material opposes the flow of current and can impact the behavior and performance of the circuit
How to use "resistance values" in a sentence
Basic
Advanced
resistance values
Proceed as follows to measure resistance values up to max.
The fatigue resistance values are advantageously preserved or improved.
Note that there are two different resistance values.
Resistance values may vary to suit the application.
Measure very low resistance values.
Low sheet resistance values are indicative of low emissivity.
This function is particularly useful for measuring resistance values.
Proceed as follows to measure resistance values consider the figures.
Such resistance values may vary according to the applications.
Polycarbonates have one of the highest impact resistance values.
Additional resistance values with equivalent resistance may be continued.
Showing different resistance values.
Additional resistance values and combinations of resistance values are possible.
Voltage can be switched to measure a broad range of resistance values.
Numerous resistance values.
See also
Dirty and damp windings have considerably lower resistance values.
This equalizes the electric resistance values of different phase windings.
Do not touch the measuring tips so as not to affect resistance values.
The resistance values for the three maneuvers were presented in order.
Dirty and damp windings demonstrate considerably lower resistance values.
Measured resistance values will be inaccurate if unable to properly zero the meter.
Data can thus be recorded in the cells based on resistance values.
Higher resistance values will exacerbate the stressing of the transformer windings.
The third and fourth resistors have equal resistance values.
Bulk densities and air resistance values are given in the following table.
Some testers will indicate voltage levels as well as insulation resistance values.
Resistance values outside of the ranges specified above may indicate a circuit error.
Use of relative penetrability and barrier resistance values is also convenient.
The resistance values thus obtained correspond to transistors having an ideal switch behaviour.
The electrically resistive paths may all have different resistance values.
You can distinguish the resistance values by the colored code on the resistor.
The possible switch combinations are listed below with their corresponding resistance values.
The transepithelial electrical resistance values remained low after addition of fresh medium.
These results are very satisfactory since they correspond to the desired resistance values.
The resistance values required to shunt the impaired electrochemical cells can vary.
The following table provides the expected resistance values for the sensor.
The electrical sheet resistance values for each film are also shown in the inset.
The additional amplifier could have a gain adjustable by means of a ratio of resistance values.
The memory may store resistance values and corresponding default voltage or power values.
These three phases make it possible to obtain resistance values prior to any printing.
The long term temperature resistance values are those temperatures above which material decomposition takes place.
The scatter appeared once again and is linked to the internal resistance values.
Your service manual should specify resistance values for the primary and secondary coils.
Armor blocks and shields will also have specific damage resistance values.
Fine adjustment of the RC product of resistance values and capacitance values will be needed.
Populating the database with the measured initial temperatures correlated to the measured initial resistance values.
This prevents a minor change to the resistance values modifying the resistive key Kr.
ConducThor is a conductive cement that drastically and permanently reduces earthing resistance values.
The Taber resistance values refer to the pulp side of the composite nonwoven material.
Typically the input output ratio is one and the resistance values are equal.
You'll also be interested in:
Examples of using Resistance
Show more
National resistance to the occupation was therefore legitimate
This must result in a resistance value of approx
Resistance to surface damage by fine particles optional
Examples of using Values
Show more
The measured values shall be plotted on a graph
Date and time revert to default values
Carrying values and estimated fair values
