Examples of 'rough opening' in a sentence
Meaning of "rough opening"
rough opening - This phrase is often used in the context of construction or events, indicating an initial phase that is challenging, unrefined, or incomplete, requiring further work or adjustments
How to use "rough opening" in a sentence
Basic
Advanced
rough opening
Carefully insert fireplace into rough opening.
Installs into a rough opening in minutes.
The rough opening for the drawer must be.
The door is now ready to insert in the rough opening.
The rough opening of the closet.
Ensure to buy a door that fits the rough opening in the wall.
Rough opening size.
The corners of the rough opening must be at right angles.
Be sure to follow the minimum clearances established in the finished rough opening dimensions.
Measure the rough opening where the single unit will be installed.
These doors come in a solid frame that must be fit into a rough opening.
Measure the rough opening where the double door unit will be installed.
A structure ( buck ) was created to support the window and simulate the rough opening.
Carefully set fireplace in front of rough opening with back of fireplace inside wall opening.
The rough opening is normally a little bit larger than the size of the real unit.
See also
This exterior structural wall defines rough opening 22 therein for receipt of a window.
The rough opening is usually a small bit larger than the size of the actual unit.
Circle the smallest measurement of the three figures, this is your rough opening height.
Rough opening weekend for the Palmetto State.
For wall thermostat applications, route supply wire from circuit breaker to thermostat to rough opening.
Rough opening must be plumb, square and level.
Note, Your rebate will apply to each rough opening.
Adjust the wall pass-through rough opening dimensions as necessary to maintain clearance requirements.
If installing in a corner, use dimensions in Figures 4b and 4c for rough opening.
If using a hearth, adjust the rough opening size as necessary to maintain minimum clearance requirements.
Using the following chart, decide which vents and rough opening ( RO ) sizes to use.
The width of the rough opening should be measured at the top, middle and bottom.
Figure 5 shows a cut away view of the expanding foam 24 being directed into rough opening gap 30.
Figure 3, Rough opening and frame measure.
You'll also be interested in:
Examples of using Rough
Show more
Inspect for signs of rough edges or peeling
Some rough waters at the end there
Maybe i was a little rough on you last night
Examples of using Opening
Show more
I am opening up a new checking account in my own name
In case of accidental opening the cycle stops
Opening of the meeting and address by the
