Examples of 'safety shutdown' in a sentence
Meaning of "safety shutdown"
A safety shutdown refers to a precautionary measure that is taken to stop or halt the operation of a system, equipment, or process to ensure the safety of individuals or the protection of property. It is typically triggered by the detection of a potential hazard, risk, or malfunction that may pose a threat to safety or cause damage if left unchecked
How to use "safety shutdown" in a sentence
Basic
Advanced
safety shutdown
The safety shutdown process is precisely defined.
If the device has triggered the safety shutdown.
That triggered a safety shutdown of the iPhone.
A safety shutdown prevents operation without the jug.
The sequence of the safety shutdown is precisely defined.
Safety shutdown in the event of overload or excess temperature.
Check the safety shutdown system.
Internal problem or unit went through an automatic safety shutdown.
Manual safety shutdown refer also to locking procedure.
Continuous red light for safety shutdown of the device.
Safety shutdown in the case of deviation from specified values is possible.
The automatic fuel reduction has initiated a safety shutdown.
If the safety shutdown is still activated.
Top of casing not closed properly safety shutdown device is tripped.
Safety shutdown due to overload and / or excess temperature.
See also
Automatic safety shutdown.
Fully automatic, central control system with safety shutdown.
Electronic safety shutdown system for motor vehicles.
In response to the earthquake the nuclear safety shutdown procedures worked.
A safety shutdown prevents the device from operating without the mixing container 1.
The automatic fuel reduction triggered a safety shutdown Remedy.
Automatic fault diagnosis, safety shutdown protection, quick adjustment and easy maintenance.
The controller is equipped with a non-adjustable safety shutdown function.
A safety shutdown feature ensures the device can not be used without the glass jar 3.
The automatic fuel reduction has initiated a safety shutdown Dirty heat exchanger Correction.
In addition, the power source receives over a safe contact information about safety shutdown.
Automatic machinery safety shutdown and slow-down controls should be separated from the alarm installation.
Ice machine stops on Safety Shutdown.
Safety shutdown - Status LED slowly flashes red.
To prevent the telescope from running against the mount, a safety shutdown after 3 hours was implemented.
A safety shutdown is carried out, - if a flame indication is present during.
Once the electricity supply is restored, the stove switches to Safety shutdown operating status.
The safety shutdown device 43 is only shown here schematically.
LED-display lights up red - Burner is so greatly soiled that a safety shutdown will be initiated.
The safety shutdown function and / or closing function are implemented by the redundant safety valves 7 - 8.
There are two independent, fast-acting safety shutdown systems as well.
Once the safety shutdown is ended, the control unit switches to the “ Fault ” operating status.
In this case, a corresponding signal is transmitted to the safety shutdown device 43.
Electronic safety shutdown The electronic signal display ( 10 ) flashes and the machine was automatically SWITCHED OFF.
Reset of overcurrent shutdown - Activation despite 3x safety shutdown parameter 8 1.
Accordingly, a safety shutdown signal is sent from the safety shutdown device 43 to the operating device 42.
Power Switch . Safety shutdown switch.
Safety Shutdown System 1 ( SDS1 ), SDS1 is designed to rapidly and automatically terminate reactor operation.
Red Sensor fault, safety shutdown active, TMax exceeded by > 5 K.
You'll also be interested in:
Examples of using Safety
Show more
Protocol for safety in sampling from shore
Safety culture is learning driven in the organization
Always follow the safety instructions carefully
Examples of using Shutdown
Show more
Clipping or total shutdown may also be result
Shutdown for decades way out of town
Associated fire safe shutdown circuit analysis
