Examples of 'sample surface' in a sentence
Meaning of "sample surface"
sample surface - the outer part or layer of something that is used as a representative example for testing or analysis
How to use "sample surface" in a sentence
Basic
Advanced
sample surface
The sample surface was polished and cleaned.
No visible defects were detected on the sample surface.
The sample surface became uniformly grey.
Readings were made at the soil sample surface.
The sample surface quality was satisfactory.
A transport of xenon towards sample surface has been observed.
The sample surface is coated with a thin layer of resist.
Visible strain distribution on the sample surface is photographed.
The polished sample surface was made the analyzed surface.
The reflectivity is linked to the index of the sample surface.
Specular reflectance from a sample surface is of a higher intensity than diffuse reflectance.
No lens was required to increase the fluence at the sample surface.
The sample surface corresponding to the cross section of the stainless steel is ground.
Microliter drop of distilled water is placed on the sample surface.
Hence a topographically image of the sample surface with nanometer resolution can be obtained.
See also
At this point a jet of material is ejected from the sample surface.
This set up will position the sample surface perpendicular to the flow of the water.
The polar axis of oriented crystals was perpendicular to the sample surface.
The delivered beam dimensions at the sample surface optionally can be manipulated by imaging lenses.
The gradient can be induced by heating or cooling the sample surface.
Light emission from the sample surface and volume is not always uniformly distributed.
This arrangement generates information on planes parallel to the sample surface.
The tissue will not be dislodged from the sample surface during further processing.
The evaluation of corrosion was taken through the observations of the sample surface.
Results of Auger analysis of the sample surface at this stage are shown in Fig.
The tissue trapping platforms can have a movable sample surface.
AFM images the topography of a sample surface by scanning the cantilever over a region of interest.
The tracing stylus moves automatically across the sample surface.
Moulded RIM sample surface is cleaned with heptane.
Image is put together by slowly scanning sample surface in a raster fashion.
Spatial distribution information is obtained by scanning a micro focused ion beam across the sample surface.
Tip approaching The approach of a probe to a sample surface consists of following actions.
The sample may be rotated to promote even polishing of the sample surface.
After being polished, each polished sample surface was etched usingnital.
This means that the measurement is only representative of the sample surface.
Signal description Height Sample surface topography.
These energies identify the elements present at or near the sample surface.
Thus, most of the sample surface is illuminated by the incident beam.
During each oscillation the tip strikes the sample surface.
The probes were pressed onto the sample surface at a separation of about 5 cm.
The cantilever tip is then literally pressed into the sample surface.
After being polished, each polished sample surface was etched using natal.
This provides elemental information about the composition of the sample surface.
Conveyor belt 26 forms a product sample surface for supporting product which is to be inspected.
The beam may be directed at a glancing angle relative to the sample surface.
In this situation, the feedback output equals the sample surface topography to within a small error.
The thermoelastic equation is used to obtain the displacement induced on the sample surface.
Figure 1 shows images of the sample surface obtained via SEM.
We measured grain boundary sliding along his perpendicular component to the sample surface.
The sample surface has to be greater than 5mm x 5mm.
You'll also be interested in:
Examples of using Surface
Show more
An uneven surface increases the risk of overturning
Where ϑ is the measured test surface temperature
All feasible surface and subsurface ECVs
Examples of using Sample
Show more
Engineer training and sample terms of reference
Sample of sequence of targets for newspaper microfilming
Mfi particulate sample mass collected at mode i mg
