Examples of 'saw arm' in a sentence
Meaning of "saw arm"
saw arm - It refers to a situation where a person witnessed an arm or limb being cut off or amputated. This phrase is often used in the context of witnessing a violent or gruesome incident
How to use "saw arm" in a sentence
Basic
Advanced
saw arm
Mount the saw arm cover back.
Bevel degree markings are on the bottom rear of the saw arm.
Lift the saw arm by the handle.
The forward section of the saw arm is loose.
Lock saw arm by depressing the lock pin.
Fit the forward section of the saw arm onto the rear.
Lower the saw arm to the horizontal position.
Positive stop adjustment screws have been provided on each side of the saw arm.
Raise the saw arm to its highest position.
Let the blade come to a full stop before raising the saw arm.
Adjust the saw arm to a right bevel angle.
Tighten the clamping lever again to fasten the saw arm in the chosen position.
Adjust the saw arm to a left bevel angle.
Remove the stop screw that limits rotation of the forward section of the saw arm.
Swing the saw arm entirely up.
See also
Turn the saw OFF and allow the blade to stop before raising the saw arm.
Swing the saw arm into the upmost position.
The saw has been shipped with the saw arm locked in the down.
Raise the saw arm to the full upright position.
Pull out the lock pin and lift saw arm to its full height.
Lock the saw arm by securely tightening the bevel lock knob.
This saw has been shipped with the saw arm secured in the down position.
Pull the saw arm all the way down and engage the.
Loosen the clamping lever ( 4 ) and swing the saw arm to the desired angle.
Adjust the saw arm to the desired bevel angle.
Disengage the lock pin ( A ) and lift saw arm to its full height.
Push down on saw arm and pull out the lock pin to.
Bevel degree markings are on the bottom front of the saw arm Fig . 7, M.
Raise and lower saw arm to ensure it functions properly.
NoTE, Make only slight adjustment to the screw, Then rotate the saw arm back to 0.
Check that the saw arm does not move when the bevel clamp handle.
Loosen the bevel clamp handle ( 17 ) and move the saw arm to the left.
Place the saw arm in the vertical position and open the wheel cover.
I was doing some labor work, and when I saw arm wrestling gambling, I thought of you.
Move the saw arm until the latch locates it at the 0 bevel position.
Remove the 6 screws oft he saw arm cover and remove the cover.
Fix the saw arm in this position by tightening the fixing knob 18.
Pull on the Release Knob ( 6 ) and lift the saw arm to its full height 2.
As you move the saw arm left and right, follow it and stand slightly to.
TRAvEl PIvoT ADJuSTMENT Your saw arm should rise completely to the up position by itself.
Move the saw arm to the left until the latch locates it at the 45 bevel.
TRAVEL PIVOT ADJUSTMENT The saw arm should rise completely to the up position.
Lock the saw arm ( bevel function ) by securely tightening the bevel lock knob.
For miter cuts fix the saw arm on the sliding bars with fixing knob 22.
Move the saw arm to the right until the latch locates it at the 45 bevel.
Loosen bevel lock knob and set saw arm at 0 bevel blade set 90 to miter table.
Bring the saw arm into the lower position and lock it with the interlock knob 23.
Swing the saw arm into the lower position and lock it with the interlock knob 23.
When the saw arm is rotated at the 45 bevel.
With the Saw Arm ( 5 ) in the raised position, use a soft brush to dust.
