Examples of 'sccm' in a sentence
Meaning of "sccm"
SCCM - a noun referring to a unit of measure used in healthcare to indicate the volume of a liquid
How to use "sccm" in a sentence
Basic
Advanced
sccm
Each flow rate is usually measured in sccm.
RF is radio frequency ; sccm is standard cubic centimeters per minute.
The flows of air and nitrogen are in sccm.
I like sccm for the following reasons,.
Scom and sccm.
Hydrogen was added at 230 sccm to control the melt index of the product.
The unit of gas flow rate in the table 2 is sccm.
Total flow through the bed was 200 sccm using helium as the diluent.
The flow rate of the carrier argon gas was 5 sccm.
A steady total gas flow of about 3500 sccm is maintained throughout the whole growth process.
The films were obtained by using oxygen flow rates varying from 15 up to zero sccm.
Ethylchloride was fed to the reactor at a rate of 18 sccm during the reaction process.
The injection rate of oxygen gas was regulated to 19 sccm.
The flow rate of the nitrogen was 100 sccm ( standard cubic centimeter minutes ).
For example, a single bore capillary can limit atmospheric arsine release to about 3 sccm of arsine.
See also
Where sccm corresponds to the unit cm 3 / min ( standard cubic centimetres per minute ).
The flow rate of the carrier He gas was 5 sccm.
The total mass flow of gas was 700 sccm ( standard cubic centimeters per minute ).
And the Oxygen gas flow rate was 1 sccm.
Flow rate, 200 sccm ( cubic centimeters per minute in standard conditions of pressure and temperature ).
The lens was first treated by passing hydrogen gas at 400 sccm into the chamber.
A flow of 20 sccm of N2 was always kept during the reaction.
The sputtering pressure is further sublimated with a pure argon flow of 173 Sccm.
In a preferred embodiment a mixture of 200 sccm Freon in 40 slm argon is used.
The nitrogen flow rate is approximately 175 sccm.
Reactive gas was introduced at a flow rate of 20 sccm and system pressure adjusted to 0.5 Torr.
The argon flow rate was 25 sccm.
Unlike Example 2, the reactor was cooled when the H2 flow decreased to 7 sccm rather than 5 sccm.
The argon flow rate preferably ranges from 0 to 30 sccm.
At this point oxygen is also entering the reactor, at 10 sccm.
The flow rate of the gasses is approximately 100 sccm.
Whereas, the oxygen flow rate for the AlTiO layer was 30 sccm.
Thereafter, argon was introduced into the chamber at a flow rate of about 100 sccm.
The reactor was purged for 15 minutes and then the flow rate established at 450 sccm.
Air flows through the annular region between the inner tube and the chimney at 1000 sccm.
