Examples of 'scrub head' in a sentence
Meaning of "scrub head"
scrub head - This phrase is unclear and needs more context to provide an accurate definition
How to use "scrub head" in a sentence
Basic
Advanced
scrub head
Put scrub head in the lowered position.
Remove idler plates from scrub head.
Raise squeegee and scrub head when transporting.
Remove shroud located above scrub head.
Raise the scrub head to the transport position.
Remove the idler plate from scrub head by.
Raise scrub head to transport position.
Located on the scrub head shroud.
Lower scrub head to floor with minimal down pressure.
Remove brush from scrub head.
Raise scrub head off floor and remove key.
Raise squeegee and scrub head.
Check scrub head skirts for wear and adjustment.
Remove squeegee from machine and raise scrub head.
Make sure the scrub head is in the raised position.
See also
Repeat steps in reverse order to install other scrub head.
Raise scrub head and reverse machine from test area.
Repeat steps for other brush on opposite side of scrub head.
Raise scrub head off floor and turn machine off.
Store machine in a dry area with squeegee and scrub head in the raised position.
Raise the scrub head with support stand to prevent a flat spot in rollers.
Measure the distance from top edge of scrub head to floor at front and rear.
Then turn main power switch to the OFF position after raising scrub head.
Lower scrub head to floor, do not apply any down pressure.
Turn the main power switch to the ON position and raise the scrub head.
Release parking brake, raise scrub head and reverse machine from test area.
Once machine is positioned, lower scrub head.
With pads / brushes installed, lower scrub head to floor and apply maximum pad pressure.
Remove any debris buildup from the underside of the scrub head Figure 30.
When storing machine, raise pad scrub head and squeegee off floor to prevent damage.
Tilt the machine back and clean the underside of the scrub head Figure 31.
Note, Loosen this bracket if scrub head does not release from machine.
Place the pad driver / brush on the floor in front of the scrub head Figure 8.
Hold switch down until scrub head actuator turns off Figure 6.
Once machine is positioned, lower scrub head and squeegee.
Make sure the scrub head is raised by turning off the brush switch Figure 6.
Press bottom half of brush pressure switch until scrub head is completely raised Figure 6.
Lower the scrub head to the floor by stepping on the transport release pedal Figure 12.
Measure distance from bottom edge of scrub head to floor at all four corners Figure 39.
Raise the scrub head to the transport position to prevent flat spot on brush Figure 27.
To stop scrubbing, release control grips, raise scrub head and squeegee.
Remove idler plate from scrub head by releasing latches on top of scrub head Figure 7.
Disconnect solution hose from scrub head Figure 49.
Check scrub head skirt ( s ) for wear and adjustment.
Clean the underside of the scrub head Figure 27.
Step down firmly on scrub head lift pedal to raise Figure 11.
Remove screws when using the disc brush scrub head Figure 50.
When transporting machine, raise the scrub head to the transport position Figure 19.
The hex spacer is required for cylindrical brush scrub head only Figure 48.
Remove two clevis pins that connect scrub head to lift arms Figure 49.
