Examples of 'secondary current' in a sentence
Meaning of "secondary current"
secondary current: This phrase refers to a flow of electric current that is derived from or influenced by a primary current source. It is often used in electrical engineering to describe a secondary circuit or component that operates in conjunction with the primary current flow
How to use "secondary current" in a sentence
Basic
Advanced
secondary current
Permits adjustment of the secondary current in the.
The secondary current may be detected as voltage on a resistor.
Maximum short circuit secondary current.
The secondary current decreases linearly with time.
Monitoring of the secondary current.
The secondary current depends on the variation of the primary current.
Permits adjustment of the secondary current in the bilevel welding mode.
There is no copper loss in the secondary because there is no secondary current.
This flux variation induces a secondary current in the secondary winding.
Result in ampacity lower than required for the expected secondary current.
Calculate the maximum secondary current and secondary voltage across the ammeter.
A wire connection furthermore gives rise to nonuniformity in the secondary current flows.
Passing the secondary current cables phase per phase through the corresponding holes.
This assembly makes it possible to manage the two alternations of the secondary current.
This central control circuit does not comprise a secondary current zero transition detection device.
See also
The secondary current heats the bar to a temperature greater than its melting temperature.
The flux passing through the coating material induces heavy secondary current in the material.
Generally the minimum operating secondary current corresponds to the consumption of the tripping circuits.
The exciting coil produces a primary field which induces a responsive secondary current in the concentrator.
Secondary Current system.
Dsp pass via the primary of the secondary current transformer Tms.
Rated Secondary Current The rated primary current divided by the marked ratio.
Thus, it is possible to determine the evolution of the secondary current over time.
Secondary current distribution in a unit chlor-alkali cell.
When device T1 is turned off, the transformer secondary current Is must continue to flow.
This so-called secondary current is proportional to the primary current.
The value of rated burden in table A shall be applicable for secondary current of 5 A.
In this manner, the secondary current is an image of the primary current.
In other words, the primary current is 20 times greater than the secondary current.
I2 is the secondary current from the phase not monitored by a transformer.
If a primary current increases, a secondary current non-linearly increases.
A secondary current i 2 exits the ideal primary via its high terminal.
Please note that values bigger than 100 % generate a secondary current bigger than welding current.
The secondary current is opposed to the primary current, creating a negative feedback.
FIG . 3 schematically shows an exemplary secondary current loop.
Analyze primary and secondary current density distribution, assuming constant electrolyte conditions.
Standards burdens for current transformers based on rated secondary current of 5A are given in Table 21.
Consequently, the secondary current Is has a phase lead with respect to Ip.
Thus, in this case, the primary current i 1 and the secondary current i 2 are equal.
Starting from the time t 1 the secondary current abruptly increases and decreases progressively down to 0 amperes.
The secondary current cables are equipped with Ø 4 mm fingers.
But, initially, transformer secondary current Is must continue to flow.
The secondary current is rectified on the output side at a rectifying circuit 114.
FIG . 3, mentioned above, schematically shows an exemplary secondary current loop known from the prior art ;.
Since the secondary current is equalized with the serial connection of secondary windings, EPMATHMARKEREP.
Rated secondary current 1A.
Secondary current for 5A.
The rated secondary current is normally standardized at 1 or 5 amperes.
The secondary current switch 30 is connected in series at least with the power switch device 20.
Is = secondary current in amperes.
You'll also be interested in:
Examples of using Current
Show more
The current national legislation on adoptions states
To temporarily alter the current programmed temperature
Current prosecutions of the crime of abduction of minors
Examples of using Secondary
Show more
No secondary cases were found following this importation
Associated and secondary data centre costs
Secondary information published in the form of reports
