Examples of 'section height' in a sentence
Meaning of "section height"
section height: This phrase likely refers to the vertical measurement or dimension of a specific section or part of an object, structure, or document. It is commonly used in technical or architectural contexts to describe the height of a designated area
How to use "section height" in a sentence
Basic
Advanced
section height
H is the nominal section height in mm and is equal to.
Ratio of the section width to section height.
H is the nominal section height in millimetres and is equal to.
These horizontal planes represent integration points along the section height.
The section height corresponds to the number of accumulated rows.
It is calculated by dividing the section height by the section width.
The section height of the tire is measured in millimeters also.
Choice of the section height.
The section height is defined by the dimension of the elementary pixel.
A selected zone is defined by the section plane and the section height.
The section height SH of the tire means a height measured from a rim diameter line RL.
The runflat tire has an unloaded and inflated section height of SH.
H is the nominal section height in millimetres, equal to.
For sizes listed in Annex 7 to this Regulation the nominal section height H is equal to.
Ratio of section height to section width of tire, or.
See also
Definitions " Aspect Ratio " means the ratio of its section height to its section width.
They have a low cross - section height and high load capacity compared with ball bearings.
For sizes listed in Annex 7 the nominal section height H is equal to.
From the Section height list, select an image height.
Definitions . " Aspect Ratio " means the ratio of a tire 's section height to its section width.
Furthermore, a section height ( sectional tire height ) is defined as SH.
At the start of the test, measure the deflected section height Z1.
H is the nominal section height in mm, equal to.
At the end of the test, measure the deflected section height Z2.
H design section height 1.
The section height of the cross-member must not be less than 100 mm.
The tire exemplary has an undeflected section height at " H " as shown in the figure.
H, is nominal section height in millimetres and is equal to Sn multiplied by 0.01 Ra.
The cross-member shall have a section height of at least 120 mm.
Is nominal section height in millimetres and is equal to Sn multiplied by 0,01 Ra where.
In this configuration, the middle section 34 has a middle section height H1 and a middle section width W1.
In addition, the design section height H of such a tire is 189 mm.
You'll also be interested in:
Examples of using Height
Show more
Height and weight are about the same
The armrest can be height adjusted as follows
Height and depth adjustable steering wheel
Examples of using Section
Show more
See following section on who is eligible to run
You will find it in the adult section
The section contains the following provisions
