Examples of 'sensor connector' in a sentence
Meaning of "sensor connector"
A 'sensor connector' refers to a device or component that is used to connect or link sensors to other devices or systems. It is commonly used in electronics and technology to facilitate the transmission of data or signals between sensors and other equipment
How to use "sensor connector" in a sentence
Basic
Advanced
sensor connector
The power generator and sensor connector is disconnected.
The sensor connector must face the rear of the microscope.
Align the back of the sensor connector to an existing.
Slide wind vane onto the smaller end of the sensor connector.
Secure the sensor connector in the desired location.
The zone sensor is fed with operating voltage via the sensor connector.
Reconnect the sensor connector to the valve connector.
Slide temperature and humidity sensor onto the smaller end of the sensor connector.
The sensor cartridge further comprises a sensor connector connected to the sensor in an initial position.
Sensor connector from the strap and rinse the strap under running water after every use.
Disconnect the spout connecting hose and sensor connector from the controller.
The external sensor connector uses the same earth as the USB digital output.
Plug water puck cable into the AIM sensor connector.
Moisture on the sensor connector must be avoided!
Note, Terminal numbers are stamped on the body of the oxygen sensor connector.
See also
Moisture inside the sensor connector must be avoided!
The sensor connector 4 is fixed on the terminal board 1 through the sensor terminal hole.
Ensure that both cable and sensor connector are dry 2.
Sensor Connector Various selection One Set/One sensor / per month.
Ensure that the cable and the sensor connector are absolutely dry 1.
An internal switch causes a low-resitance between Pin 4 and 10 of the sensor connector.
In this embodiment, the sensor connector 4 for measuring temperature is a conductive post.
Insert 4 type A screws into the holes of the sensor connector.
Align the keyway on the Sensor connector and latch in place, verify latching.
Two gaskets 5 are sleeved on the sensor connector 4.
Unscrew the protective cap from the sensor connector and keep it for future use 1.
Make sure that the O-ring is positioned on the sensor connector 3.
Insert the media sensor connector 1.
As shown in Fig.4, the temperature measuring end comprises a sensor connector 4 and gaskets 5.
Screw the cable connector 2 on to the sensor connector 3 and tighten it by hand.
Thus, when the insertion site is sterilized, the remote sensor connector 864 is also sterilized.
You'll also be interested in:
Examples of using Connector
Show more
Only the appropriate connector must be used
Purple connector for black whip antenna
Plug the charger connector into the
Examples of using Sensor
Show more
Search for the sensor or check batteries
Sensor readings and radio communications are terminated
An integrated light sensor also measures brightness
