Examples of 'sensor wires' in a sentence
Meaning of "sensor wires"
sensor wires: Refers to the conductive wires or cables used in electronic devices or systems to transmit data from sensors to processing units
How to use "sensor wires" in a sentence
Basic
Advanced
sensor wires
Connect the sensor wires to the operator.
Disconnect one of the flame sensor wires.
Attach the new sensor wires to the connectors.
Chemical contamination can occur in PRTs if a liquid reaches the lead or sensor wires.
Inspect sensor wires for a disconnected or cut wire.
Connect the level sensor wires.
Level sensor wires are disconnected.
Disconnect the yellow and black sensor wires from the gateway.
The sensor wires must not come in contact with the.
Insert the floor temperature sensor wires into terminals c and d.
The diagnostics may also determine whether there is a short circuit for the sensor wires.
Check whether the sensor wires are damaged or not.
Before testing the resistance values of the wires, switch power off and disconnect sensor wires.
Connect the sensor wires to the operator see below.
Depending on the location of the oil pressure sensor wires relative to the.
See also
Solder the two sensor wires to any two motor leads.
There are replaceable / optional hall sensor wires available.
Floor Sensor wires may not be connected.
Find the red and yellow sensor wires and bridge them.
Attach the sensor wires into the thermostat following the instructions on page 8.
The five female plugs are connected to four sensor wires and one common ground.
Floor Sensor wires may be crossed.
Check to see that the Safety Reversing Sensor wires are connected to the.
The ohm-meter sensor wires are then connected directly to the copper wires on the sample.
For example, diagnostics may test whether pressure and temperature sensor wires are correctly connected.
Check whether the sensor wires are plugged in the ECU properly.
The supplied sensor harness -7 - consists of four individual sensor wires.
One or more additional sensors or sensor wires can be positioned in this fourth lumen.
Remove safety reversing sensors from brackets and shorten sensor wires to 1-2 ft.
Try cleaning the MAF sensor wires or filament with aerosol electronics cleaner.
For example, if a mold requires 30 sensor devices, 60 analog sensor wires would typically be required.
Connect the rain sensor wires to the wiring terminal ports ( yellow in color ) labeled “ Sensor ”.
The n+1 female plugs are connected to n sensor wires and 1 common ground.
These sensor wires are numbered from 1 to 4.
Electrician, Check if the Floor Sensor wires crossed and shortcircuited.
Insert and pass two Pulse Sensor wires ( 5 ) through the hole in the Front Post 87.
Remove sensors from brackets and shorten sensor wires to 30-60mm from back each of sensor.
Inspect the safety reversing sensor wires for a short ( staple in wire ), correct wiring.
Switch the black and brown sensor wires and test again . See Figure 3.
You'll also be interested in:
Examples of using Wires
Show more
Do not operate if wires and terminals are exposed
Wires can be difficult to see when flying
Connect house wires to ventilation fan wires
Examples of using Sensor
Show more
Search for the sensor or check batteries
Sensor readings and radio communications are terminated
An integrated light sensor also measures brightness
