Examples of 'service valves' in a sentence
Meaning of "service valves"
Service valves: This term likely refers to valves used in a mechanical or industrial context to control or regulate the flow of fluids or gases
How to use "service valves" in a sentence
Basic
Advanced
service valves
Service valves on liquid and gas discharge.
Ensure that the service valves on the outdoor.
Service valves on compressor gas discharge.
A wide variety of port service valves.
Modern service valves incorporate an electric shutoff solenoid.
To prevent damage to unit or service valves observe the following.
Close service valves and shut off vacuum pump.
This is to prevent damage to the unit and service valves.
The service valves will open or close in response to the input.
Use quenching cloth for brazing operation at the service valves.
Service valves in the heat pump outdoor unit not open.
Connect vapor tubing to fittings on outdoor unit vapor service valves.
Service valves are closed from the factory and ready for brazing.
Align the center of the piping and sufficiently fit to the service valves.
Control box and service valves are located outside for easy service.
See also
Check that the gas and liquid side service valves are fully open.
Wrap service valves and filter drier with a wet cloth or heatsinking material.
The unit should be installed with service valves on both the inlet and outlet.
Open the service valves before the operation, otherwise there might be the burst.
Make sure both the gas and liquid side service valves are fully open.
The service valves are connected to connector SV1 and SV2 when the input is active.
Flare-type cooling connections with service valves.
Seal the two and three way service valves with the corresponding protective covers.
During this step, conductivity is not monitored and the service valves remain closed.
In single filter systems, the service valves of the cylinder must be connected to “ SV1 ”.
Fully back seat ( open ) liquid and vapor service valves.
The service valves are connected to the terminals of connector V1 and V4.
Connect the vacuum pump with 250 micron capability to the service valves.
Service valves of Class 0 shall withstand a pressure of 2.25 WP in the open and closed position.
Evacuate the system to 250 microns or less using suction AND liquid service valves.
Service valves of Class 1 shall withstand a pressure of 6750 kPa in the open and closed position.
Open both service valves ( V1 and V2 ) on the hot water and cold water lines.
You'll also be interested in:
Examples of using Valves
Show more
Open the valves all the way
Valves have not seated on that rebuild
Seven different valves are produced in the building
Examples of using Service
Show more
I like room service and indoor plumbing
Service delivery is an important component of health systems
You have been a great service to your country
