Examples of 'servo arm' in a sentence
Meaning of "servo arm"
A mechanical arm or limb that is controlled by a servo mechanism, typically used in robotics or automation systems
How to use "servo arm" in a sentence
Basic
Advanced
servo arm
Attach the clevis to the fl ap servo arm.
The servo arm will be centered in the slot.
Use only supplied servo arm screws.
Attach the servo arm perpendicular to the servo centerline.
Connect the fl ap linkage to the servo arm.
Remove the servo arm from the servo.
Attach the clevis to the servo arm.
Attach the servo arm parallel to the hinge line.
Attach the clevises to the servo arm.
The servo arm can then be reinstalled on the servo.
Attach the ball end to the servo arm.
Secure the servo arm so it is perpendicular to the servo centerline.
Connect the metal clevis to the aileron servo arm.
Secure the connector to the servo arm in the location shown.
Connect the linkage clevis to the rudder servo arm.
See also
Always make sure a servo arm is fully attached to the servo.
Center the servo and install the servo arm.
Align the servo arm with the line on the cover.
With the servo centered and servo arm attached.
Fit a servo arm on the servo so the arm is perpendicular to the servo.
Disconnect the steering clevis from the rudder servo arm.
Attach the linkage to the servo arm or control horn after adjustment.
Secure the brass pushrod connector to the throttle servo arm.
Install the servo arm on the servo as well as the servo mount.
Use a clevis to attach the throttle linkage to the servo arm.
The rudder servo arm can be removed to attach the ball ends.
Attach the two remaining clevises to the rudder servo arm.
Operate the servo without the servo arm for test purposes.
Attach the servo arm to the rudder servo perpendicular to the servo centerline.
Align a ruler along the center of the servo arm slot.
Using a longer servo arm will help obtain the best throttle geometry.
Attach the pushrod connector to the throttle servo arm as shown.
Place the servo arm on the servo output shaft parallel to the hinge line.
Connect the throttle pushrod to the servo arm using a nylon pushrod keeper.
Snap the front tail pushrod linkage onto the tail servo arm.
Attach the pushrod connector to the servo arm to the aileron servo arm.
Tighten the setscrew in the connector to secure the pushrod to the servo arm.
Position the servo on the cover so the servo arm is centered in the slot.
Attach the second cable end to the outer holes of the servo arm.
Secure the servo arm to the servo using the hardware included with the servo.
Center the tail servo and attach the servo arm to the servo.
The servo arm and swashplate should be in horizontal / neutral position.
Mark the pushrod where it crosses the hole on the steering servo arm.
If not, adjust the servo arm by using the trim function on your radio.
Press the bottom end of the servo linkages on the servo arm linkage balls.
Fit the servo arm to the servo, aligning one arm perpendicular to the pushrod.
Make sure the tapered washer is between the ball link and servo arm.
Once the ball ends are attached, the servo arm can be secured to the servo.
Use a toothpick to apply the CA to prevent gluing the connector to the servo arm.
Connect the linkage to the servo arm in the hole indicated in Step 7.
