Examples of 'set the control' in a sentence
Meaning of "set the control"
The phrase 'set the control' refers to the act of adjusting or configuring the settings or parameters of a control device or system. It implies the action of selecting or inputting specific values or options to achieve a desired outcome or functionality. 'Set the control' could apply to various contexts, such as adjusting temperature controls, configuring audio settings, programming a remote control, or configuring software options
How to use "set the control" in a sentence
Basic
Advanced
set the control
Set the control dial to the position.
Use a small screwdriver to set the control.
Set the control dial to its minimum setting.
That is to set the control point.
Set the control device to the maximum temperature.
This allows you to precisely set the control valve.
Set the control to a higher setting.
Press and release to set the control level in the meter.
Set the control to your desired output setting.
As soon as the time switch is set the control lamp glows.
Press to set the control level in the meter.
Prior to switching on the subwoofer, set the control.
Set the control on the lance.
This menu is used to set the control mode for the motor.
Set the control panel language.
See also
Follow the procedures below to set the control panel back to standby mode.
Set the control to cold or to provide a normal refrigerator temperature.
Adjustment of tap fittings Set the control knobs to minimum.
To set the control parameters for the individual cameras.
Adjustment of the taps Set the control knobs to minimum.
Set the control parameters for the humidity control if activated.
If it is too dark, set the control knob to a lower level.
Set the control to the coldest setting to store fresh meats.
When it is not in use, set the control switch to the locked position.
Set the control surfaces to the stated values at the transmitter.
To switch on the alarm, set the control lever to the middle position.
Set the control panel display language and location if necessary.
Once it is fully melted, you can set the control to the required cooking temperature.
Set the control to the desired setting between these limits.
To adjust the speed of your sander, set the control knob to the desired number.
Set the control knob of the oven modes in the lowest position.
Fasten the wall holder, then set the control unit on the magnetic holder.
Set the control knob so that the amount of feedback will be minimal.
Using a flat bladed screwdriver, set the control to the desired setting between these limits.
Set the control card set display appearing on the operator station for vendor use.
When the desired quantity has been dispensed, set the control lever back to the central.
Always set the control to minimum before connecting any audio source.
After the product warms up, the product prompts you to set the control panel language.
You can also set the control parameters in kV.
To warm serving bowls and plates, set the control on LO.
This switch is used to set the control function of the extra function connection.
To warm serving bowls and plates, set the control on LOW.
To begin with set the control knob for the browning degree to medium level.
Prior to initial operation, set the control VOLUME.
You can set the control unit at the maximum level to obtain a faster warm up.
Choose your preferred controller and set the control scheme that best suits your playstyle!
Set the control lever in the Neutral position.
Prior to initial operation, set the control VOL.
Set the control panel to Registration mode as follows.
At the end of the second drain, set the control to the Off position.
You'll also be interested in:
Examples of using Set
Show more
These targets are set as cumulative national goals
Set days and time of regeneration or recharge
The units may be set to different channels
