Examples of 'set to position' in a sentence
Meaning of "set to position"
The act of placing or adjusting something in a particular location or arrangement
How to use "set to position" in a sentence
Basic
Advanced
set to position
The steam control is set to position see.
If switch is set to position I or Position II mixer will start automatically.
The steam control may have been set to position.
Set to position 5 on the thermostat scale.
The air outlet is set to position or.
The function selector switch of the electrical equipment cubicle must be set to position 7.
The switch is set to position A after the manufacturer 's test.
When the air flow direction is set to position.
When selector is set to position 1, all the inputs are separate.
The steam control has been set to position O.
The main switch is set to position -0- to switch off the device.
The reversing switch has been set to position A.
V3 is set to position A and the carbon-isotope monoxide is transferred to the reaction chamber 50 within 15 s.
The process continues until the speed control is set to position 0 off.
When the rotary switch is set to position 1, a bus scan can be performed.
See also
The saw is supplied from the factory with the screw set to position 2.
Ensure that the thermostat control is set to position « 0 » before the appliance is switched on.
The function selector switch on the IQnomic plus module must be set to position 7.
Switch Sw is set to position 1.
Room temp . thermostat tripped and automatic mode set to position 2.
The switch must be set to position 0.
The module 's function selector switch must be set to Position 6.
Is switched off when it is set to position 0/AUS/OFF.
Initially, the temperature control should be set to position 4.
The rotary switch on the FAM14 is set to position 1, its lower LED flashes red.
Maintaining the same temperature conditions, the switch 16 is then set to position B.
The corresponding selection means 26 A is then set to position “ 1 ”, since a switch must be powered first.
Nanoe is produced when the main switch ( K ) is set to position 1 to 3.
The steam control is set to position 0.
The lawnmower stops moving forwards when lever ( 1 ) is set to position “ N ”.
Standard three-speed pumps must be set to position 3 full speed.
The PLURIMOD EASY module is shipped with preadjustment set to position 4 - fully open.
Make sure all control knobs are set to position “ OFF ”.
Make sure that all burner knobs are set to position “ OFF ”.
For storage purposes, the handle assembly can be set to position 2 or 3, as follows.
Here, it is absolutely necessary that the function switch is set to position [ 0 ] " OPERATE.
Make sure that the FUNCTION switch ( 19 ) on the device is set to position TAPE OFF.
You'll also be interested in:
Examples of using Set
Show more
These targets are set as cumulative national goals
Set days and time of regeneration or recharge
The units may be set to different channels
Examples of using Position
Show more
Then position the unit as shown below
Verify the correct position of the gasket
Try to position cages out of direct sunlight
