Examples of 'shaft by' in a sentence
Meaning of "shaft by"
shaft by - It seems like a partial phrase or incomplete sentence and doesn't provide a clear context to determine its meaning
How to use "shaft by" in a sentence
Basic
Advanced
shaft by
Loosen gear from shaft by using an arbour.
Shaft by hand until it engages the shaft lock.
The flanges are mounted on a shaft by sealed bearings.
Blender shaft by removing the adhesive tape.
We will meet in the main shaft by the elevator.
Turn the shaft by hand to check free rotation.
Fluid will be released down pilot shaft by gravity feed.
Remove the flex shaft by reversing the removal procedure.
The cylinder is supported via the shaft by two bearings.
Remove the drive shaft by loosening the catch and pull the shaft out the back.
Gothic arch groove of a nut and a shaft by four points.
Thread line head onto output shaft by turning it anticlockwise until head is tight against.
The cams are linked to a machine drive shaft by a drive belt.
Dismount the flex shaft by removing the two split pins.
Replace the collet assembly onto the shaft by hand only.
See also
Remove the mixing shaft by turning it to the left.
I would say dropped down the bottom of a mine shaft by now.
Do not mount onto the shaft by hitting with a hammer.
Thread the poppet valve housing onto the inner shaft by hand.
They are thus fixed to the rotor shaft by means of complementary shapes.
Additional to the HFO is the HFF design flanged shaft by QD.
The nut is fixed to the rotor shaft by performing screw fastening.
The half-shells are hinged to a clevis of the shaft by a pin.
The propeller fixed to the shaft by means of a threaded connection and a gasket.
Its head was not separated from the shaft by a real neck.
Additional torque loss on input shaft by electric consumers corresponding to maximum electric power Nm.
The bearing is mounted on the steering shaft by means of a ring.
Additional torque loss on input shaft by electric consumers corresponding to minimum electric power Nm.
Never attempt to repair a damaged or cracked hook or shaft by welding or straightening.
Wash the plastic shaft by swishing it in clean, warm water.
Touch circular arch groove of a nut and a shaft by two points.
Temporarily lock the output shaft by inserting a hex wrench through both holes.
So the body could not have entered the shaft by that chute.
There is an elevator shaft by Delta Sky Lounge without an elevator.
The forceps are retained within the hollow shaft by a catch member.
Wash the plastic shaft by swishing it in clean, warm.
Then screw the nylon cutting head onto the shaft by turning it.
Lock the shaft by tightening the screw 3.
It is only disclosed an example of drive shaft by a direct drive motor.
The 30s get the shaft by society because it is the middle child.
The valve has a disc mounted on a shaft by means of a sleeve.
Rotating the drive shaft by further 90 ° will result in the first position.
The pulley is rendered rotatable with the shaft by a releasable coupling.
Block the rotation of the shaft by inserting the hexagonal wrench [ 3 ] in the appropriate hole 4.
The second cover may be fastened to the shaft by a fastening member.
Remove reamer from its shaft by unscrewing 5/16 ″ set screw with an Allen wrench.
The disc is also balanced and centred on the shaft by this fixing.
The force applied to the shaft by the article is detected by a load cell 50.
Thread small end of threaded stud into gearcase output shaft by turning clockwise.
Fix the control cable and shaft by the fastener ( 1 ) in the area shown in the.
You'll also be interested in:
Examples of using Shaft
Show more
This is the shaft of the pry bar
Shaft seal depends on water for lubrication
Blind hollow shaft or hollow through shaft
