Examples of 'si content' in a sentence
Meaning of "si content"
Si content: Likely a typo, but could refer to being satisfied or content in Spanish
How to use "si content" in a sentence
Basic
Advanced
si content
Si content also affects thermal expansion of the alloy.
Immersion temperature in terrns df Si content in the bath.
The Si content should be as low as possible.
The slag exerts a compensating effect on the Si content.
Despite the low Si content a significant ageing effect is observed.
Significant cost is sometimes required to reduce the Si content.
A clear basipetal increase in Si content was found in the endodermis of all cultivars.
This effect is of particular relevance in a steel with a high Si content or Cu content.
The lower limit of the Si content need not especially be defined.
The amount of attached polyorganosiloxane is calculated from the Si content thus obtained.
Higher Si content reduces the solidification and solid state shrinkage rate.
In this case the specified minimum Si content is not applicable.
A reduction of Si content will increase the coefficient of thermal expansion of the weld bead.
A key feature of the novel alloys of this invention is the relatively high Si content.
Al may partly substitute the Si content in the steel processed according to the invention.
See also
Si content was measured using XRF as well.
Effect of initial Si content.
Low Si content has the effect of reducing propane formation and decreasing catalyst deactivation.
The alloying additions take into account the Fe and Si content of primary Al.
If the Si content is too low, this effect can not be obtained.
A composition like that of the invention, however not mentioning an Si content is examplified.
However, an excessive Si content makes fabrication of a separator difficult due to a decrease in workability.
In the case of containing Al described later, the Si content and the sol.
The smaller the Si content is, the more the cold workability is improved.
Parameters affecting the test, i.e. strain rate and Si content ofsteels were investigated.
However, when the Si content is too high, the toughness of steel will be reduced.
Therefore, the upper limit for the Si content is 1 %.
On the other hand, a higher Si content deteriorates the weldability or hot-workability.
Si content in bath,.
On the other hand, an excessively high Si content rather deteriorates the SSC resistance.
If the Si content exceeds 2 %, the weldability and hot workability are decreased.
From chemical equlibrium considerations, a Si content of 20 % should be expected.
However, when the Si content is too high, the hot workability of the alloy deteriorates.
For a good deoxidation, it is preferred to adjust the Si content to at least 0.2 %.
On the other hand, if the Si content is too high, SSC resistance will deteriorate.
Si content of less than 0.5 % can not achieve the desired effect, and is therefore not desirable.
Table 6 shows the effect of Si content on metal loss in a typical P / M sintering atmosphere.
It is more preferable that the lower limit of the Si content be 0.08 % or more.
Further, the higher the Si content is, the higher a temperature at which austenite transformation occurs.
This action is brought about when the Si content is 0.6 % or higher.
An Si content exceeding 3.0 % leads to deterioration of press formability and degrades the surface quality.
This effect appears at an Si content of 0.2 mass percent or greater.
When a Si content is less than 1.8 %, the strength of a matrix tends to be insufficient.
In a more preferred embodiment the sum of the Si content is in a range of 9 % to 11 %.
When the proportion Y of the Si content is more than 10 atomic %, high-temperature strength decreases drastically.
For providing such effects, it is necessary that the Si content is 0.1 % or more.
In the invention, the Si content is limited to at most 1 % by mass.
This effect is realized in the case where the Si content is 0.1 % or more.
On the other hand, if the Si content is too high, the SSC resistance decreases.
In an embodiment according to the present disclosure, the Si content may be 1.0 % or less.
You'll also be interested in:
Examples of using Content
Show more
On the product content and environmental release
Content management interfaces for web systems
Adjusts style and content when necessary
Examples of using Si
Show more
This warranty si not valid for any
Si does not need any help in that department
Our next stretch si going to be for the shoulders
