Examples of 'side broom' in a sentence
Meaning of "side broom"
side broom ~ A side broom is a cleaning tool with bristles or brushes attached to the side of a sweeper or cleaning machine. It is used to sweep debris, dirt, or dust along the edges or corners of floors, walls, or other surfaces that may be harder to reach with a conventional broom or vacuum
How to use "side broom" in a sentence
Basic
Advanced
side broom
Side broom height check and adjustment.
Check that the side broom pattern is as shown in.
Continuous use of the side broom.
The side broom height can be adjusted.
Put the replacement side broom on the shaft.
Lower side broom arm and replace hopper.
Slide your hand under the side broom and press.
Raise the side broom when sweeping in an open area.
Remove the retaining screw in the bottom middle of the side broom.
Main and side broom cleaning.
The machine has now been reprogrammed to use the new side broom height position.
Assemble the side broom in the reverse order of.
This will turn on the vacuum motors and activate scrub and side broom systems.
Check that the side broom print is as shown in the.
Perform step 1 again to check that the side broom is at the.
See also
Main and side broom with harder and softer.
Keep the machine stationary and allow the side broom to rotate for a few seconds.
Dustguard side broom mist system will not function.
Before operation, you must attach the handle and side broom to the main sweeper housing.
And side broom are turned on.
Once inside of the “ Adjust Mode ” perform the following steps to adjust the side broom.
Check the side broom distance from the fl oor as shown.
NOTE, The machine should be stored with the Side Broom in the raised position.
Put the side broom in the DOWN position.
Remove the large Pin ( CC ) holding the side broom on and remove the broom.
Ensure Side Broom OFF switch is not selected push switch to turn ON.
Raise the hopper until the side broom is approximately at chest height.
If side broom rotates in the wrong direction, the belt is not installed correctly.
Check the correct height of the side broom from the ground, by proceeding as follows.
The Side Broom stop must be re-adjusted when ever the broom has been replaced.
Lift the hopper until the side broom is approximately at chest height.1.
The Side Broom height must be re-adjusted whenever a broom has been replaced.
Lower the vacuum deck and side broom using the Vacuum Deck Raise / Lower Lever 11.
Side broom height adjusting knob5.
Hopper lift / side broom lever see figure 9.
Attach side broom to the side broom pulley with screws, lockwasher and washers.
A-7 right side broom lift and power control.
Side broom height should be adjusted to have approximately 1/3 of the bristles touching the floor.
Carry out the Side Broom Height Adjustment as described in the previous paragraph.
The side broom sweeping pattern is adjusted by turning the Side Broom Height Adjustment Knob 10.
Remove the side broom by squeezing the two tabs together as shown in figure 3.
Side broom motor circuit breaker20.
Use the side broom only for the edges, borders and corners.
Scrub and side broom systems will start when the Drive Pedal ( 2 ) is activated in forward.
The side broom ( 11 ) can be lifted and lowered even if it is turned on.
