Examples of 'signal bandwidth' in a sentence
Meaning of "signal bandwidth"
signal bandwidth - The range of frequencies within a signal that can be transmitted by a device or system
How to use "signal bandwidth" in a sentence
Basic
Advanced
signal bandwidth
This is done to obtain the largest signal bandwidth.
The instantaneous signal bandwidth is related to the range resolution.
Furthermore switched capacitor techniques have a reduced signal bandwidth.
W is the signal bandwidth.
This leads to optimum channel estimation within the signal bandwidth.
The overall interfering signal bandwidth is sufficient to block all control signal channels bandwidth.
Operation is virtually transparent in use and full signal bandwidth is maintained.
The signal bandwidth of output 10 is far larger than the signal bandwidth of output 6.
Setting the measurement frequency and signal bandwidth is just as easy.
The minimum signal bandwidth can be achieved for roll-off factor equal to 0.
Different countries use different channel raster and signal bandwidth.
For digital signals, the input signal bandwidth is considered to be half the sampling rate.
This signal loss can be over some or all of the signal bandwidth.
Transmitted pulse signal bandwidth exceeding 3 kHz;.
Selecting a subchannel bandwidth to be sufficient to transmit the voice signal bandwidth continuously.
See also
The resulting signal bandwidth is approximately 9.6 kHz.
The sampling frequency is selected to be much higher than the signal bandwidth.
FIG . 2 graphically shows an example of the Ku signal bandwidth 10 and the Ka signal bandwidth 12.
Power consumption in a wireless communications receiver scales with received signal bandwidth.
In the third signal scheme, the excess signal bandwidth ratio, a, is reduced.
There is consequently a need for proposing a solution for detecting a signal in a signal bandwidth.
No interference is shown with the lower layer signal bandwidth up to 5.2 MHz.
Said small signal preferably must be located outside of desired modulation signal bandwidth.
An IF lowpass filter 66 having cutoff frequency fIFH limits the signal bandwidth entering the detector 68.
It should be understood that a bandwidth of the TOF should be less than a signal bandwidth.
For example, the carrier frequency is 1 GHz and the modulating signal bandwidth is 1KHz.
In particular, timing estimation accuracy is inversely proportional to the signal bandwidth.
Gain ripple is a condition where the gain varies across the signal bandwidth.
The pulse width of this timing signal determines the instantaneous UWB signal bandwidth.
A Nyquist transmission based on Nyquist pulses is used to limit signal bandwidth.
Further, the receiver according to the invention has an adaptable signal bandwidth.
Thus, the opportunities offered by the circuit are improved with respect to the signal bandwidth.
For example, the transmitter pulses may have other shapes that may reduce a required signal bandwidth.
In case of a Generic signal, the menu shows an option to select the signal bandwidth.
Due to Nyquist 's theorem, its quenching frequency must be at least twice the signal bandwidth.
Therefore, frequency selective fading affects only a small part of the CDMA signal bandwidth.
Such an RX filter would be narrower than the standardized WCDMA / HSPA signal bandwidth.
In the micro case, the front end draws 1µA maximum current with a 2MHz signal bandwidth.
IF digital receiver 511 may filter each channel to establish the signal bandwidth.
The -33 dB value is for the portion of the curves within the 24 MHz signal bandwidth.
You'll also be interested in:
Examples of using Bandwidth
Show more
Upgrade of bandwidth and connectivity performance to COs
You must have really great bandwidth
The entire bandwidth is output without filtering
Examples of using Signal
Show more
Give me a signal when you want me to start
You have to use one signal at a time
Signal strength indicating connection between units
