Examples of 'signal-to-noise' in a sentence
Meaning of "signal-to-noise"
signal-to-noise (noun) - a ratio used in communication and imaging to compare the level of a desired signal to the level of background noise
Show more definitions
- The ratio comparing signal power to noise power.
- The quantity of quality information compared to irrelevant or incorrect information.
How to use "signal-to-noise" in a sentence
Basic
Advanced
signal-to-noise
Proper measurement of smaller earthquakes requires a higher signal-to-noise ratio.
Increasing the signal-to-noise ratio enables messages to be more clearly received.
The result is correlatively a considerable amelioration of the signal-to-noise ratio.
The advantage is the increased signal-to-noise performance as compared to previous methods.
The digitized seismograms were filtered as a means of improving signal-to-noise ratios.
These improved signal-to-noise ratios lead to an improvement of the measuring range.
Transmit power may be defined based on a signal-to-noise ratio at an access terminal.
This signal-to-noise ratio is not sufficient to render the quantization noise inaudible.
In the following a possible implementation of a signal-to-noise ratio estimator shall be described.
The signal-to-noise ratio can be measured on a constellation diagram of said electrical signal.
This combination of effects leads to a substantial degradation of the signal-to-noise ratio.
Measurement of the signal-to-noise ratio of the receiving channel of the satellite being considered.
An improvement in the data rate corresponds to an increase in the signal-to-noise ratio.
The signal-to-noise ratio does not depend on the amplitude of the modulation signal.
Its purpose is to increase the apparent signal-to-noise ratio of the resultant signal.
See also
An optical condenser system was developed using fixed lenses to increase signal-to-noise ratio.
Another known method for improving the signal-to-noise ratio is referenced as stacking.
This setting usually provides sufficient power reserves at optimum signal-to-noise ratio.
A matched filter maximizes signal-to-noise ratio of the input signal to the system.
The quality of a compression method often is measured by the peak signal-to-noise ratio.
The sensitivity and signal-to-noise ratio are then affected by the existence of such an interface.
Multiple spectra are acquired and averaged until a sufficient signal-to-noise ratio is achieved.
The way in which this signal-to-noise ratio is obtained in a base station is explained below.
The advantages of the concept and a comparative analysis of signal-to-noise ratio are described.
Means for assessing the signal-to-noise ratio operating on the resulting electrical signals.
The effect of the low coupling coefficient is to reduce the signal-to-noise ratio.
The signal-to-noise ratio is compared with a homodyne detection of the type described hereinbefore.
The demodulator is capable of calculating the signal-to-noise ratio on each of the carriers.
Very favorable signal-to-noise ratio by virtue of the very narrow passband which is necessary.
It is therefore necessary to strongly bias them in order to have a satisfactory signal-to-noise ratio.
A continuous generator could be used but the signal-to-noise ratio is better in a pulsed generator.
Another important characteristic of a position sensor is the amplitude of the signal-to-noise ratio.
The signal-to-noise ratio of positron annihilation is markedly improved over unidirectional gamma rays.
This makes it possible to implement these algorithms with low signal-to-noise ratio.
A signal-to-noise ratio improvement technique may cancel the observation of these hard misfires.
Two types of noise are likely to influence the signal-to-noise ratio of the converter.
This increased signal-to-noise ratio probably resulted from the purity of the immunoadsorbent.
This possibility contributes to improving the signal-to-noise ratio of the signals obtained.
The signal-to-noise ratio and the total harmonic distortion improve significantly as well.
The presence of the dark current leads to a deterioration of the signal-to-noise ratio.
This may improve the signal-to-noise ratio so that lower light levels are detected.
This operating procedure permits an improvement of the signal-to-noise ratio of the measurement.
Its advantages are a high signal-to-noise ratio and a high spatial resolution in the vertical dimension.
Such an approach can be relevant to identifying the signal-to-noise ratio of the sample.
The signal-to-noise ratio represents quality of the audio signal fed into the speakers.
Such an arrangement would significantly increase the signal-to-noise ratio of nucleotide detection.
This increases the signal-to-noise ratio and enables the controller to reduce response time.
The arrangement according to the invention is also reliable at low signal-to-noise ratios.
This setting enables a high signal-to-noise ratio and provides the best audio quality.
The error values have been calculated as the inverse of the signal-to-noise ratio.
