Examples of 'socket head' in a sentence
Meaning of "socket head"
socket head: This phrase typically refers to a type of screw or bolt that has a recessed end (socket) instead of a traditional head. The socket is designed to accommodate a corresponding tool, such as an Allen wrench, for tightening or loosening the fastener.
How to use "socket head" in a sentence
Basic
Advanced
socket head
The socket head screws are zinc coated.
Loosen the two socket head bolts.
Inner socket head cap screw for handle fixing.
Slightly undo hex socket head bolt.
Hexagon socket head screws of stainless steel.
Screw in countersunk and socket head screw.
Flanged socket head cap screws.
Loosen booth hexagon socket head.
Hexagonal socket head cap screw.
Replace bracket and secure it with socket head bolt.
Square socket head cap screw.
Replace and tighten the socket head screws.
Loosen the socket head screw and remove the.
Secure the pushrod guide with a socket head cap screw.
Remove socket head screw and nut from dust guide.
See also
Be sure to tighten the hex socket head bolt securely.
Tighten the socket head screws placed on the motion arm.
To dismantle firmly fitted parts a socket head wrench is provided.
This is a socket head bolt normally associated with a scraptool like.
Such a structure makes it possible to achieve a cheaper socket head liaison.
Unscrew hex socket head bolt.
Remove socket head bolt and washers holding belt table on sander.
Other hexagon socket head screws.
Loosen socket head bolt and move belt table parallel to belt.
Ring and gear are kept in place by means of socket head screws.
Loosen and remove socket head bolt from bracket.
First remove the holder by unscrewing the hex socket head bolt.
Tighten the socket head bolts.
The socket head bolt may have a fixed position relative to the knuckle.
Then secure the hex socket head bolts very carefully.
Then install the cover plate on the cartridge using socket head screws.
Pull the hexagon socket head wrench out of the drilling again.
Lift the safety cover until it touches the hexagonal socket head bolt.
A high tensile socket head screw is then screwed into the hole.
Separate the magazine from the nose by removing four socket head cap screws.
Open the socket head screw on the bayonet socket with an allen key.
Remove exhaust deflectors and four hex socket head cap screws holding cap to.
Place the socket head screw through the dust guide and tab.
Tighten the ratchet lock lever and both hexagon socket head cap screw.
Install the two socket head cap screws and hardened washers provided.
Remove the belt table by removing the socket head bolt and flat washer.
Only tighten socket head screw so that hydraulic brake can just be turned.
Keep inserting the bit inside the hexagonal socket head hole until it makes contact.
Loosen the socket head screws that secure the miter fence to the saw base.
Attach the rear support from below with four hexagonal socket head screws and washers.
Loosen the hex socket head bolt with the hex wrench provided.
Basic multipurpose screw which is equipped with Allen hex socket head cap.
Then secure carefully the hex socket head bolts on either side of the base.
After base adjustment, turn the three hex socket head.
Assemble cap using four socket head cap screws and replace exhaust deflectors.
