Examples of 'soldered' in a sentence
Meaning of "soldered"
Solder means to join or mend metal pieces together by melting a filler metal into the joint
Show more definitions
- simple past tense and past participle of solder
- Fastened by means of solder.
How to use "soldered" in a sentence
Basic
Advanced
soldered
The coffin was soldered without a vent hole.
Soldered memory can not be easily upgraded.
Cable must be soldered into the contacts.
Impurities in the solder or on the surfaces to be soldered.
Cable can be soldered to the contacts or crimped.
May be cut to length and end soldered on.
Cables were often soldered in place at one end.
Compression fittings are not as robust as soldered fittings.
The soldered chip is placed in the panel.
The quality of the soldered product is good.
There are no longer any electrical wires to be soldered.
Copper fittings for soldered plumbing joints.
I soldered into the circuit board.
This buzzer must be soldered on to the print.
A soldered link in a greater chain reaction.
See also
The components are soldered directly to one another.
Systematic visual inspection of all soldered joints.
Various parts soldered together by following instructions.
The remaining rivets are then soldered in turn.
The wires are soldered to the collector strips.
Even difficult geometries can be soldered easily.
The clips are soldered or crimped into place.
Removable connectors are preferred over soldered connections.
Components were soldered into the boards by hand.
All other components will be soldered down.
The shim is soldered to the ferritic metal.
Apply a thin layer of flux to all surfaces to be soldered.
The element may be soldered to the substrate.
Soldered to a bulb and covered with match heads.
The plate is then soldered to the casing.
Soldered point smooth and shining.
The substrate is suited to be soldered to a chip or a circuit.
Soldered wires coming out the loop is here.
The jacks are first soldered to the boards.
No soldered joints for easy maintenance.
With plug and soldered resistor.
Its soldered to the board inside.
They were built of stones soldered with mud or plaster.
I only soldered them from the reverse side.
The assembly may be soldered subsequently.
The components may then be positioned and soldered.
Parts which were to be soldered on a circuit board are as follows.
The problem was that a piece of pipe was soldered poorly.
It is likely soldered onto the mother board.
The end can be whole soldered.
Cable must be soldered into the contact pins.
Reliable mechanical strength of soldered points.
I even soldered the runners myself.
If only the ladies soldered correctly.
Thoroughly clean the surfaces to be soldered.
