Examples of 'solids contents' in a sentence
Meaning of "solids contents"
solids contents - It refers to the amount or percentage of solid substances present in a mixture, solution, or material
How to use "solids contents" in a sentence
Basic
Advanced
solids contents
This is done by conducting the copolymerization at high solids contents.
The new solids contents were determined by weighing the pieces.
Potassium is preferred where very high solids contents are desired.
These high solids contents are achieved by a bimodal filler particle size distribution.
It is notable that these compositions have relatively low solids contents.
Greater increases in solids contents of polymer polyols are needed to meet market demands.
Polysaccharides and organic matter influence the soluble solids contents in the fruits.
We have found that solids contents in these ranges result in the best shape memory.
The cakes obtained by press filtration generally have fairly high solids contents.
Higher solids contents and lower temperatures tend to make the liquid confectionery material more viscous.
The coagulation temperature of the latex also decreases with increasing solids contents.
The emulsion products had solids contents comparable to that obtained in Example I.
Monomeric melamine resins allow the formulation of coatings with higher solids contents.
The formulations of these solids contents are as follows,.
The spectrum ranges from pure gas to water or oil with differing solids contents.
See also
Table 2 lists interpolated values of solids contents at selected viscosities.
The sludges resulting from such dewatering treatments still have only relatively small solids contents.
Secundo, lower viscosity allows high solids contents in the final binders.
In the present invention, compositions contain the resin at high solids contents.
However, higher solids contents may be achievable with different microfiltration equipment and microfilters.
HRS scraped surface technology concentrates to higher solids contents than competing technologies.
Suitable solids contents generally range from about 5 to 30 weight percent.
In this way, stable aqueous dispersions are obtained that have solids contents as specified above.
Solids contents as prepared preferably range from 30 weight percent to 50 weight percent or higher.
In general for all compositions of gels studied, increasing the solids contents increased the viscosity.
The solids contents are ascertained by heating a weighed sample at 125°C to constant weight.
A preferred SRI profile will show solids contents within the following ranges,.
Polyol composition with an initial solids content of 70 % was concentrated to different solids contents.
Table 4 provides more detail about solids contents of typical inks including those of Table 3.
The solids contents are determined by heating a weighed sample to 125°C until constant weight is reached.
Urea solutions can be prepared at solids contents up to about 50 % by weight.
Solids contents of 35 to 50 weight percent or even more are accordingly desired.
Air dry metric tonne of pulp meaning dry solids contents of 90.
For electrodeposition use, resin solids contents of 5 to 20 percent by weight are often used.
The aqueous dispersion so produced can be prepared with total solids contents from 20 % to 60 %.
The solids contents of the base coats then is ≧ 40 % by weight.
These polymer polyols have polymer solids contents generally in the range of 5 to 50 wt %.
Total solids contents as high as 80 % or higher, for example, can be achieved.
In normally occurring fibrous screenings, total solids contents exceeding 35 % will be achieved.
Clean ( metallic bright ) 3 lateral run-out using a dial gauge 3 visible damage 3 corrosion protection excluding solids contents.
Fully diluted electrodeposition baths generally have resin solids contents of 3 to 25 percent by weight.
Diluted sludges having solids contents ranging from 2 % to about 12 % were prepared and tested.
In contrast, end products typically have total solids contents of 30 % or less.
The suspension may have a non-volatile solids contents of from about 10 to about 50 percent by weight.
In fact, solution rubbers can be prepared which have solids contents in excess of 90 %.
The suspension may have non-volatile solids contents of from 10 to 50 percent by weight.
Preferred intermediately concentrated feed juices have juice solids contents of from 30 ° to 37 ° Brix.
In all the examples, the solids contents ( SC ) are expressed as % by weight.
The composition had a solids contents of 5 % w / w.
Preferably a fat with a solids contents of about 8 at 15°C is to be used.
You'll also be interested in:
Examples of using Contents
Show more
Remove all contents from upper cabinet
I am afraid we had to evacuate your stomach contents
To learn the contents of the file materials
Examples of using Solids
Show more
The solids feared our metamorphic abilities
A sieve separates solids from used liquids
Solids liable to become liquid during transport
