Examples of 'speaker impedance' in a sentence
Meaning of "speaker impedance"
In the context of audio systems, 'speaker impedance' refers to the electrical resistance that a speaker presents to an audio signal. It is measured in ohms and affects the ability of an amplifier to deliver power to the speaker efficiently
How to use "speaker impedance" in a sentence
Basic
Advanced
speaker impedance
You can set the speaker impedance.
Speaker impedance ratings are less than precise.
Overheated by too low speaker impedance.
Speaker impedance must be set as shown below.
But please observe the correct speaker impedance.
Speaker impedance and allowed input.
Use only speakers with the same speaker impedance as.
Adaptive processing of speaker impedance flattens frequency amplitude and phase characteristics.
Press to activate impedance protection to protect your amplifier from low speaker impedance.
Check that the minimum speaker impedance for that model is correct.
The setting of the POWER MODE switch varies according to the speaker impedance.
Compliance with minimum speaker impedance information for all channels must be maintained at all times.
Read before starting the procedure Speaker Impedance.
Too low of a speaker impedance may also cause Protect to light.
Before connecting them to your amplifier, check the speaker impedance range of your amplifier.
See also
Too low speaker impedance may also cause PROTECTION to light.
In bridged mono operation minimum speaker impedance is 4 Ohms.
Too low speaker impedance may also cause PROTECT to light.
Only for use with at least 8 Ohms speaker impedance.
Too low speaker impedance may also cause PROTECT LED to lit up.
This amplifier has been designed for a speaker impedance of 6 to 8 Ohm on each channel.
Speaker impedance and the SPEAKER IMPEDANCE switch settings.
From the amplifier 's point of view, the speaker impedance changes depending on the sound frequency.
Set speaker impedance in the advanced setup menu before connecting the speakers page 57.
When adopting this type of configuration, the speaker impedance must never fall below 4 Ohm.
Minimum speaker impedance for bridged operation is 4 ohms.
If you wish to bridge-connect a speaker, the speaker impedance must be no less than 4 ohms.
Change the unit 's speaker impedance settings depending on the impedance of the speakers connected.
Speaker outputs ( sure seal connectors ) Speaker impedance.
Selecting the speaker impedance Speaker Impedance.
Check speaker impedance load if below 1 Ohm, rewire speakers to achieve higher impedance.
Impedance too low Check speaker impedance Min 2 ohm Stereo, 4 Mono.
Speaker impedance This is an AC resistance value, indicated in Ω ohms.
Note, The recommended speaker impedance for use with MusiQ is 8 ohms.
Speaker impedance depends on used main amplifier ** height without feet.
Total external speaker impedance < 4ohm.
The speaker impedance must be at least 4 Ohm DIN rating.
Changing the speaker impedance setting SP IMP.
Check speaker impedance load if below 2Ω, rewire speakers to achieve higher impedance.
Check your speaker impedance on page 7.
Min. speaker impedance Input level Input impedance.
Again, minimum speaker impedance is 4 ohms.
Speaker impedance 2 ~ 4ohm Connect to chassis ground of vehicle.
The minimum final speaker impedance should not be lower than 1 Ohms.
SID - Speaker Impedance Detection ( automatically calibrates amplifier to your speakers ).
Set the speaker impedance to match your speakers . 40.
Speaker impedance is less than prescribed for the 540R.
Min. speaker impedance all channels min.
Speaker impedance 8 ohms Headphones impedance 32 ohms.
Minimum speaker impedance 2-channel operation Bridge operation.
You'll also be interested in:
Examples of using Speaker
Show more
Pair your speaker with your device
Wall mounting the rear speaker system
Check your speaker wires and connections
Examples of using Impedance
Show more
Speaker impedance ratings are less than precise
You can set the speaker impedance
Check the impedance of the connected speakers
