Examples of 'speed is reduced' in a sentence
Meaning of "speed is reduced"
speed is reduced: This phrase typically refers to a situation where the velocity or pace of movement is decreased or slowed down. It can be used in various contexts such as in driving, technology, or any other scenario involving acceleration or movement
How to use "speed is reduced" in a sentence
Basic
Advanced
speed is reduced
The fan speed is reduced by one step.
During reverse motion the speed is reduced.
Speed is reduced when using white ink.
Strong vibrations or the rotation speed is reduced.
Fan speed is reduced every minute.
If the SmartstartTM button is pressed in the speed is reduced.
In case of overload the speed is reduced by the electronics.
Volume adjustment may be a few seconds late when vehicle speed is reduced.
The maximum speed is reduced in the lower torque stages.
Thus the reading and write speed is reduced.
Maximum speed is reduced and the road can carry more traffic.
When the engine speed is reduced.
Our speed is reduced and our movements to all controls may not be steep.
On cotton programmes the maximum spin speed is reduced automatically.
Tsunami Speed is reduced in shallow water as wave height increases rapidly.
See also
The flow only calms down when its speed is reduced.
The speed is reduced and the following is added,.
The figure below is a simplified diagram showing how speed is reduced with distance.
Wakes, wind speed is reduced and rapid changes in.
More time is spent in each port and cruising speed is reduced to save fuel.
If engine speed is reduced again, consult with an authorized servicing dealer.
The mechanical brake is applied once the rotor speed is reduced vÃa blade pitch.
If during control the speed is reduced by applying the brake, control is stopped.
At this movement, the approach speed is reduced.
As air enters the duct, its speed is reduced while its pressure and temperature increase.
As a result, his agility and speed is reduced.
For this purpose, the casting speed is reduced and / or the lubricant flow rate is increased.
Consumption increased, the torque and speed is reduced.
If the blower speed is reduced to a minimum, Climatronic is switched off.
In order to increase the temperature, the fan speed is reduced.
Unless the enemy 's speed is reduced by midnight.
As the silicon level is increased, this critical speed is reduced.
After 5 minutes intensive speed is reduced to the second speed.
In addition, the welding latitude increases if the welding speed is reduced.
If inlet pressure is too low, motor speed is reduced to prevent suction occlusion.
Consequently the price of the apparatus is increased and it 's speed is reduced.
When the button is released, the motor speed is reduced at a constant rate of deceleration.
In lower gears, there is more available power while the speed is reduced.
Then the speed is reduced and 7 is added.
A method according to claim 1, in which the speed is reduced by successive stages.
Furthermore, speed is reduced with respect to open-loop systems.
As the room temperature nears the setting, fan speed is reduced automatically.
The engine speed is reduced to 4 seconds.
A deceleration phase is performed thereafter, where the speed is reduced by steps to zero.
The speed is reduced by one setting after every 30 minutes and.
However, if the torque of the shift actuator is suppressed, a rotating speed is reduced.
After 3 hours stirring speed is reduced to 2 rpm.
If the value at the collector sensor drops below this, the speed is reduced.
Character 's speed is reduced by half.
By using a vane design with a flat receiving end, the runaway speed is reduced.
You'll also be interested in:
Examples of using Reduced
Show more
The original should be reduced as little as possible
Reduced throughput time from production to delivery
Border delays must be reduced as much as possible
Examples of using Speed
Show more
The speed of the vacuum source shall be
I must have hit speed dial by mistake
Zoom speed is determined by the amount of rotation
