Examples of 'starter solenoid' in a sentence
Meaning of "starter solenoid"
starter solenoid ~ is an electromagnetic switch in a vehicle that plays a crucial role in starting the engine. When the ignition key is turned, the solenoid transmits an electric current to the starter motor, initiating the engine's cranking process
How to use "starter solenoid" in a sentence
Basic
Advanced
starter solenoid
Reconnect the white wire to starter solenoid.
The starter solenoid is essentially a large relay itself.
Starter motor or starter solenoid failure.
The starter solenoid is located on top of the starter motor housing.
No power to the starter solenoid.
A failing starter solenoid can leave a motorist stranded and a vehicle inoperable.
Cut the positive cable that powers the starter solenoid.
The starter solenoid receives power from the battery at all times.
This starting system mounts in the place of the starter solenoid.
Follow the wires from the starter solenoid to the starter relay.
Current will flow from the battery to the starter solenoid.
The starter solenoid is the component that sends electrical power to the starter.
Locate the two metal contacts on the back of the starter solenoid.
In a car or truck, the starter solenoid is part of an automobile starting system.
Place the blade of a screwdriver across both contacts to short out the starter solenoid.
See also
Locate the starter solenoid and refer to its circuit, provided in a car manual.
Remove hex nut and lock washer from battery power terminal on the starter solenoid.
In this case, the starter solenoid and starter should be inspected for failure.
Unplug and disconnect the wire and battery cable from the terminals on the starter solenoid.
If motor runs, replace the starter solenoid.
Do not over-tighten the terminal nuts on starter solenoid.
The charging system, starter motor or starter solenoid can be affected.
If a low voltage or 0 volts is indicated on terminal B, replace starter solenoid.
Connect the battery positive ( ) cable to the starter solenoid terminal as shown.
Listen carefully, as you should hear a click when the starter solenoid engages.
Connect the positive ( + ) cable to the starter solenoid terminal.
If motor 's working fine, then test car starter solenoid.
Use a 6 ” long, 10 gauge insulated wire as a jumper to connect starter solenoid terminal A and terminal C.
You'll also be interested in:
Examples of using Solenoid
Show more
Clean solenoid valve and replace it if necessary
The computer energizes a solenoid to achieve lockup
A solenoid may be used as an actuator in a valve or switch
Examples of using Starter
Show more
Starter fluid or firelighters should not be used
Then pull recoil starter briskly again
Oem starter rebuild kits for atv
