Examples of 'stirrer speed' in a sentence
Meaning of "stirrer speed"
Stirrer speed: Refers to the rate at which a stirring implement moves, often used in cooking or laboratory settings
How to use "stirrer speed" in a sentence
Basic
Advanced
stirrer speed
The stirrer speed was again increased to produce a good blend.
Turning the knob to a higher number increases the stirrer speed.
Stirrer speed was increased to reaction speed and the reactor heated vía a jacket.
Of course, particle size will vary with stirrer speed.
The stirrer speed was increased as the viscosity increased to ensure efficient mixing.
PO2 regulation may be done by regulating stirrer speed or aeration rate.
The stirrer speed was then reduced and the mixture was left standing overnight.
The dissolved oxygen was controlled to 25 % saturation by varying stirrer speed.
Always build stirrer speed slowly and never stir more rapidly than necessary.
When the bulk step was finished, the stirrer speed was reduced to 50 rpm.
The stirrer speed is linked to the water feed rate and the reaction temperature.
After the bulk step was finished, the stirrer speed was reduced to 50 rpm.
Stirrer speed appeared to have a minimal effect on CO2 levels.
The control knob labelled “ Stir ” on the front panel controls the stirrer speed.
Concomitantly the stirrer speed was reduced stepwise after 36 hours of cultivation.
See also
The control knobs labelled “ Stir ” on the front panel control the stirrer speed.
A constant stirrer speed of 100 rpm was maintained throughout the polymerization.
The dissolution settings were according to USP type II apparatus with stirrer speed at 100 rpm.
A top stirrer at a stirrer speed of 800 rpm was used for this purpose.
Aeration of the mix was avoided by limiting the stirrer speed to < 60 r . p.m.
Increasing the stirrer speed in order to maintain the vortex, if required, and.
A fluid dispersion is formed at a stirrer speed of ca . 400 rpm.
The stirrer speed was turned on to 50 % and the measurement of the background was taken.
During all four fermentations, the pO2 was / is controlled at 5 % by adjusting the stirrer speed.
The stirrer speed was increased to 700 rpm and the clay mixture added.
Diagrams demonstrate the dissolution properties at a stirrer speed of 100 rpm compared to 50 rpm.
The stirrer speed was increased to 500 rpm and maintained over the reaction time.
Stirrers are added to both chambers and the stirrer speed is set at about 1200 rpm.
The stirrer speed was brought to 18 rpm.
Experiment G was repeated except that the stirrer speed was reduced to 750 r . p.m.
The stirrer speed was brought to 400 rpm, and the reaction proceeded.
When the GP1 had been finished, the stirrer speed was reduced to 50 rpm.
Increase stirrer speed and add ( 2 ), continuing to stir until viscous and homogeneous.
The dissolved oxygen tension ( DOT ) was controlled at 20 % air saturation by changing the stirrer speed.
Afterwards the stirrer speed was adjusted to 250 rpm.
You'll also be interested in:
Examples of using Speed
Show more
The speed of the vacuum source shall be
I must have hit speed dial by mistake
Zoom speed is determined by the amount of rotation
Examples of using Stirrer
Show more
Attach the stirrer to the drive axle
Stirrer for even results without burn
Water and a magnetic stirrer are added therein
