Examples of 'strain rates' in a sentence
Meaning of "strain rates"
Strain rates are the rate at which deformation occurs in a material subjected to stress, typically measured in units of strain per unit of time
Show more definitions
- plural of strain rate
How to use "strain rates" in a sentence
Basic
Advanced
strain rates
Improvers in crankcase lubricants subjected to high strain rates.
Strain rates decreased with increasing total times of testing.
The dashed lines represent higher strain rates.
Strain rates are higher for experiments in which crack propagation occurred.
The tests can be described as tensile tests at relatively high strain rates.
These microstructures in granitic rocks indicate strain rates under intermediated to high temperatures.
The chordae exhibited viscoelastic properties in that extensibility decreased with increasing strain rates.
More sets of drawing rolls or lower strain rates would further lower the processing speed.
However, the procedure may be used at differing strain rates.
The polymers recipes and strain rates are shown in Table II.
Special attention was taken into the material behav-ior modeling under low and high strain rates.
Do not use excessive speed when bending since high strain rates can cause surface cracking.
Parameters identification of Johnson-Cook constitutive law was carried out for Inconel 600 at high strain rates.
The embrittlement is enhanced by slow strain rates and low temperatures, near room temperature.
A strain hardening index ( SHI ) can be determined at different strain rates.
See also
Plots of the polymer strain rates against melt flows are shown in Figure 2.
The process works under closely controlled conditions of temperature and strain rates which allow certain.
The GEAR model uses global strain rates and seismicity since 1977 to produce an earthquake forecast.
Quartz piezometer yield palaeo-stress estimates that allow to calculate strain rates inferring a power flow law.
This model uses global strain rates and seismicity since 1977 to forecast future events.
Few test data are available in the open literature for strain rates up to 10 ^ 2/s.
At low strain rates in compression distortion of the lamellar structures occurs ( McElhaney and Byars, 1965 ).
The results from model orientation experiments are provided in Figure 12 for strain rates of 200mm/min.
Metallic materials - Tensile testing at high strain rates - Part 1, Elastic-bar-type systems.
The measurements were performed at 180 °C and at different Hencky strain rates.
You'll also be interested in:
Examples of using Rates
Show more
Household borrowing rates have remained steady
Rates of disability and handicap among children
Effects of changes in rates of exchange and inflation
Examples of using Strain
Show more
Strain relief is required for all hardwiring
I guess the strain was just too much
Strain relief connector for electrical cable
