Examples of 'stuffing box' in a sentence
Meaning of "stuffing box"
stuffing box - a chamber that houses a gland, packing material, and a sleeve in mechanical equipment to prevent leaks
Show more definitions
- An assembly containing a seal, or sealing material, around a shaft.
How to use "stuffing box" in a sentence
Basic
Advanced
stuffing box
Unpack stuffing box using standard methods.
Measure gland nose or stuffing box bore.
The stuffing box is under negative pressure.
Soft gaskets and stuffing box packings.
Stuffing box can be replaced under system pressure.
I found the plastic stuffing box underneath it.
My only preoccupation is with the stuffing box.
The stuffing box is dripping a bit too much.
Piston pump with end stuffing box.
Flush the stuffing box with a liquid lubricant.
Water flows around the stuffing box.
Various types of stuffing box are available as an alternative to shaft seals.
C appropriate accessory must be used stuffing box heater.
The stuffing box can only be replaced when there is no pressure on the valve.
We just had a stuffing box installed.
See also
In one embodiment the inlet comprises a stuffing box.
What is a stuffing box.
Never wind a coil of packing into the stuffing box.
In another embodiment said stuffing box housing is directly connected to said housing arrangement.
Choice of cartridge mechanical seals or stuffing box packing.
In a preferred embodiment said stuffing box means are rotatable with respect to said housing arrangement.
Remove the driveshaft by sliding it out of the stuffing box.
Loosen the stuffing box.
The magnetic coupling has several advantages over a traditional stuffing box.
Could be the stuffing box.
The wireline will typically enter the outer tubular member vÃa a stuffing box.
Incorporates a stuffing box.
A stuffing box housing which is made of a plastic material can be produced with low costs.
Even though the stuffing box.
The bonnet and the stuffing box are sealed with special graphite gaskets and packing rings.
Single seal ring stuffing box.
Loosen stuffing box slightly with a screw wrench 7.
Ensure each ring is seated fully in stuffing box prior to installing next ring.
The soft metal inserts reduce the wear life of the stuffing box.
The rear of the nut of the stuffing box receives a clamp for retaining the cable.
The flange is closed either with a simple cover or with a stuffing box device.
In this case, a stuffing box holder can be omitted.
Be sure to reinstall the nylon washer between the universal and the stuffing box.
Preferably a sealing ring is positioned between said stuffing box housing and said housing arrangement.
Chesterton recommends not more than five to seven rings be used in the stuffing box.
Finally, the stuffing box is linked to the pump casing.
The cable may then traverse a well head sealed by means of a hydraulic stuffing box.
In stuffing box versions, the shaft is protected by a stainless steel sleeve.
The result is that the ring nearest the bottom of the stuffing box never seats.
In some embodiments, the stuffing box may be provided with a lantern ring.
Clean packing gland and gland follower to insure free insertion into the pump stuffing box.
Check stuffing box for excessive clearances and shaft / stem for eccentricity.
I Can have one seal or stuffing box.
The stuffing box prevents sea water from entering the boat 's hull.
As a result we are returning to a more simplified and economical Stuffing Box format.
