Examples of 'suction line' in a sentence
Meaning of "suction line"
suction line - In engineering and fluid mechanics, a suction line refers to a pipe or conduit that is used to draw or transport fluid from one location to another. It is typically connected to a pump or suction device, creating a vacuum or low-pressure region that allows the fluid to be pulled or sucked into the system
How to use "suction line" in a sentence
Basic
Advanced
suction line
Insulate suction line in order to avoid condensation.
There is an air leak in the suction line.
The entire suction line set requires.
There is an infiltration of air in the suction line.
The suction line is thus continuously evacuated.
Priming is accelerated if the suction line is full.
Cleansing of suction line of dental care unit.
Boric acid metering pump suction line.
Restricted suction line due to blockage or undersize pipe.
Air pocket or leaks in suction line.
Install suction line to pump head.
Check all connections on suction line.
Check the fuel suction line for restriction.
Suggested installation position on suction line.
Study of losses in the suction line of a dental unit.
See also
Connect air pressure switch to fan suction line.
It is essential that the suction line is free of air leaks.
This is particularly important for the suction line.
Air leak in suction line bubbles in water returning to pool.
Install suction weight to suction line.
The intake suction line should be kept as short as possible.
Clean the filter of the fuel suction line.
Another suction line.
This creates a rapid flow of water in the suction line.
Check the suction line.
Refrigerant flow is controlled by the temperature in the suction line.
Check all connections on suction line and shaft seal.
This is a one way valve that is attached to a suction line.
Core spray suction line.
This depends on the length and diameter of the suction line.
Temperature sensor in the suction line or refrigerant liquid inlet line.
It is used as weight for suction line.
Suction line should have continuous slope from lowest point in line.
To prevent condensation the entire suction line must be insulated.
To bleed the suction line it is important to strictly adhere to the following procedure.
Look at the suction line.
Ensure the suction line is straight and angles up toward the pump.
A pressure signal corresponding to the suction line pressure is provided as well.
The suction line should ideally slope gently towards the unit.
The liquid refrigerant is subcooled by low pressure suction line refrigerant.
A leak in the suction line will draw in air and obstruct priming.
Another potential blockage is kinking or crimping of the suction line itself.
Check all connections on suction line and shaft seal other causes.
Fill pot with water at least to the level of the suction line.
Clean the filter in the oil suction line and in the pump.
The liquid to be discharged enters the pump through the suction line.
Add a pressure cut out value in suction line to avoid too low temperature.
Another cause might be that there is an air leak in the suction line.
The suction line should ascend towards the pump to prevent air locks.
The pump will prime in a few minutes depending on suction line length.
You'll also be interested in:
Examples of using Line
Show more
One in a long line of successful cop marriages
Select the data to display on that line
Those withdrawals are in line with international law
Examples of using Suction
Show more
Place the suction cup on your windshield
You selected a too high suction power
Powerful suction could cause serious injury
