Examples of 'surface of the unit' in a sentence
Meaning of "surface of the unit"
This phrase refers to the outer layer or top part of an object or device, specifically a unit. It signifies the visible or exposed layer that covers or encloses the unit, providing protection or serving a functional purpose
How to use "surface of the unit" in a sentence
Basic
Advanced
surface of the unit
Collecting on the surface of the unit.
Allow the surface of the unit to dry completely before using.
It may damage or fade the surface of the unit.
On the surface of the unit sphere.
They may attack the surface of the unit.
Clean the surface of the unit with a clean damp soft cloth.
They are here to scratch the surface of the unit.
The surface of the unit should carefully inspected for visual damage.
Doing so could damage or cause the surface of the unit to fade.
Wipe the surface of the unit with a soft, damp cloth.
Stick the supplied cover sheet on the surface of the unit.
The features of the outer surface of the unit load also are of importance.
This may cause damage or deterioration to the surface of the unit.
Wipe over the outside surface of the unit with a dampened cloth and polish.
Do not use chemical solvent to clean the surface of the unit.
See also
To clean, wipe the surface of the unit with a dry cloth.
Not spray any liquids directly onto any surface of the unit.
Do not wipe the surface of the unit by alcohol, thinner or benzene.
Use a soft dry cloth to wipe the surface of the unit clean.
Clean the surface of the unit with a soft cloth, water and soap.
Of the external area of the corresponding surface of the unit packet on which.
Wipe the surface of the unit with a clean, dry soft cloth as needed.
Do not use benzine or thinner as they could damage the surface of the unit.
If the surface of the unit becomes dirty, wipe it with a soft dry cloth.
A metallic conductor strip is uniformly spread over the whole surface of the unit.
Do not touch the hot surface of the unit such as cylinder, muffler and gearcase.
Do not use thinner or alcohol as they may damage the surface of the unit.
Clean the surface of the unit with a damp cloth, then dry with a duster or.
The serial number of this product may be found on the surface of the unit.
The exterior surface of the unit will, therefore, simulate the face of a time piece.
Use a damp cloth to remove dirt and dust from the surface of the unit.
The laminated surface of the unit may be wiped clean with non-abrasive household cleaner.
These instruments typically provide a direct reading with gauges on the surface of the unit.
Only the touch sensing surface of the unit 26 need be provided.
The Limited Warranty does not cover physical damage to the surface of the Unit.
Clean the surface of the unit with a moistened ( not wet ) cloth.
Be careful, trying to avoid contacting hot surface of the unit.
Follow the above procedures, but carefully clean the surface of the unit after initial drying.
During storage, a clearance of 1 " must be maintained from the top surface of the unit.
Use a clean, dry, soft cloth to wipe the external surface of the unit.
The tip-over prevention bracket 1 is set on the top surface of the unit.
You'll also be interested in:
Examples of using Unit
Show more
Then position the unit as shown below
Place unit in the fi nal installation location
Any institutional unit may hold valuables
Examples of using Surface
Show more
An uneven surface increases the risk of overturning
Where ϑ is the measured test surface temperature
All feasible surface and subsurface ECVs
