Examples of 'surfaces must' in a sentence
Meaning of "surfaces must"
Surfaces must refers to the requirement or necessity for certain surfaces to meet specific standards or conditions. This phrase is commonly used when discussing safety or cleanliness protocols, such as surfaces that must be sanitized, disinfected, or meet certain specifications to prevent accidents or contamination
How to use "surfaces must" in a sentence
Basic
Advanced
surfaces must
Aged epoxy or polyurethane surfaces must be roughened up.
These surfaces must be covered with greeneries.
Smoothness of all the sanitized surfaces must.
Old existing surfaces must first be roughened up.
Minimum distances from adjacent object surfaces must be observed.
Sample surfaces must be prepared very carefully.
Counter or support surfaces must be level.
All surfaces must be free from intrusions.
Center or support surfaces must be level.
Wood surfaces must be varnished or thick glazed.
Close contact between the surfaces must be maintained.
The surfaces must be dry and clean.
The colour of artifi cial surfaces must be green.
Painted surfaces must be dry and hardened.
In the optimum situation these three surfaces must be parallel.
See also
Pipe surfaces must be smooth and straight.
Insered into the machine frame frontal surfaces must be aligned.
The irradiated surfaces must be resistant to heat.
Surfaces must be cleaned thoroughly and often.
Sensor field surfaces must be kept clean.
Surfaces must be clean before they can be painted.
All disturbed surfaces must be stabilized.
Surfaces must also minimize the likelihood of slips.
Loose or cracked work surfaces must be replaced or repaired.
The surfaces must be dried immediately after disinfecting.
Mismatch of the mating surfaces must not exceed the tolerance.
The surfaces must be dried immediately after cleaning.
Files with flat mounting surfaces must be secured with set screws.
Surfaces must be smooth and bottoms as flat as possible.
The two articular surfaces must be put in place quickly.
Surfaces must be absolutely clean to ensure sound brazed joints.
Rotors and braking surfaces must be free of oil and grease.
Surfaces must be clean and dry free from contaminant.
At least two of the flat surfaces must have an angle between them.
All surfaces must be cleaned when construction is completed.
Deactivation of the laser is required when strongly glossy or reflecting surfaces must be measured.
All surfaces must be cleaned with disinfectant.
Cylinder base surfaces and motor mount surfaces must be milled to match before assembly.
Often surfaces must be protected against corrosion.
In order to obtain smooth contact said involute surfaces must be accurately designed and machined.
Exposed surfaces must be thoroughly cleaned or bleached.
For continued safe operation, these surfaces must be repainted.
Painted surfaces must not be touched during heating.
Sharp-edged interruptions on the friction surfaces must be avoided.
Enamelled surfaces must not be touched during heating.
After alkali or emulsion washing, the surfaces must be rinsed clean.
Enameled surfaces must not be touched during heating.
Also, the formation of condensation or undesirable mould on surfaces must be prevented.
The surfaces must be stored horizontally.
In addition to that, the pipe surfaces must not be wet with water.
