Examples of 'switch on the transmitter' in a sentence
Meaning of "switch on the transmitter"
Switch on the transmitter is an instruction to activate a device that sends out radio signals
How to use "switch on the transmitter" in a sentence
Basic
Advanced
switch on the transmitter
This is done easily with a switch on the transmitter.
Switch on the transmitter if you have not done it already.
The channel changeover switch on the transmitter is wrongly set.
Switch on the transmitter and then the receiver.
Push the throttle lever fully down and then switch on the transmitter.
Switch on the transmitter before starting the car.
Assign Trims to any trimmer or switch on the transmitter.
Switch on the transmitter while the button is pressed.
Pull and hold the Trainer Switch on the transmitter while turning the transmitter on.
Switch on the transmitter and connect the battery.
Control Surface Centering Switch on the transmitter and connect the battery.
Switch on the transmitter.
With the helicopter switched off, first switch on the transmitter.
Never switch on the transmitter when it is connected to the charger.
Ensure that ” your ” channel is not already in use before you switch on the transmitter.
See also
Set the sliding switch on the transmitter to automatic mode.
The two-dog unit has five buttons and a toggle switch on the transmitter.
Switch on the transmitter and set it to the transmission channel of the receiver.
On / Off power switch To switch on the transmitter please push the button.
Switch on the transmitter and then connect the receiver voltage supply.
Switching on the model, Always switch on the transmitter first, then the receiver.
The switch on the transmitter will be toward the pilot when in this mode.
Press and hold the RESET button ( with a pointed implement ) and switch on the transmitter.
We recommend that you switch on the transmitter first and then subsequently the receiver.
Set the sliding switch to “ ON ” to switch on the transmitter.
Switch on the transmitter and move the throttle control lever to the full throttle position.
Now use the ON / OFF switch to switch on the transmitter.
Switch on the transmitter and then the receiver and check if the system works properly.
For this purpose, proceed as follows, Switch on the transmitter.
Switch on the transmitter by sliding the power switch to ON.
Press the " ASC " button and switch on the transmitter again.
Switch on the transmitter and connect the receiver voltage supply see chapter Voltage supply.
Turn the ON / STANDBY / OFF switch on the transmitter to the ON position.
Switch on the transmitter turning the commutator to the position I.
Turn the power switch on the transmitter to the ON position.
Switch on the Transmitter and the Model.
Bring the GAIN switch on the transmitter to position H high power.
Switch on the transmitter first, then the receiver.
Set the channel select switch on the transmitter to channel A or B as required.
Switch on the transmitter first, then switch on the receiver.
Always first switch on the transmitter and then the receiver;.
Switch on the transmitter first, then power on the aircraft.
Sensitivity switch on the transmitter High / Low.
Switch on the transmitter with the button ON /.
Servo reverse switch on the transmitter was accidentally set to „ REV “.
Switch on the transmitter and activate the V-mixer.
Switching on, Always switch on the transmitter first, then the receiver.
Switch on the transmitter using the On / Off switch.
Set the OFF / ON ( 3 ) switch on the transmitter to the ON position.
Switch on the transmitter with the sliding switch 17.
You'll also be interested in:
Examples of using Transmitter
Show more
Never operate the transmitter in places where it is
Transmitter with adhesive tape for affixing
Carefully place the transmitter on the antenna
Examples of using Switch
Show more
The floating switch is blocking in automatic operation
Opera never survived the switch to electric
Set the switch to the correct position
