Examples of 'switchpoint' in a sentence
Meaning of "switchpoint"
Switchpoint is a noun referring to a device in railway engineering that enables trains to change tracks
How to use "switchpoint" in a sentence
Basic
Advanced
switchpoint
Four levels with one switchpoint each.
Correct the switchpoint settings and the control range settings of the electrode.
Cut electrode rod according to switchpoint.
Checking switchpoint and function Lower water level until it is below MIN level.
Use button if you first want to establish the proportional band or a different switchpoint.
The length of the electrode rod determines the switchpoint for the water level limit.
Checking switchpoint and function - continued.
Water level has reached or is below switchpoint MIN.
Raise liquid level until switchpoint 2 within the desired control range is reached.
Cut electrode rod to the length dictated by the switchpoint LW.
The difference between switchpoint 2 and switchpoint 3 gives the proportional band Xp.
Cut electrode rod to the length required for MIN switchpoint.
Checking switchpoint and function ( MAX alarm ) Fill vessel until MAX level is exceeded.
Replace electrode rod and cut new rod to the length dictated by the switchpoint HW.
During operation, Level below switchpoint MAX water level, MAX LED illuminated green.
See also
Water level has reached or exceeds switchpoint MAX.
This switchpoint “ Low water level ( LW ) ” is determined by the length of the electrode tip.
Water level above MAX switchpoint.
The switchpoint “ High level ( HW ) exceeded ” is dictated by the length of the electrode rod.
Water level below MIN switchpoint.
In FIG . 2 a, the switchpoint consists of a tracking element Y of large dimension.
The lower limit of the proportional band Xp is now selected switchpoint 3.
High-water level switchpoint not reached - High level alarm Fault.
Replace level electrode and cut electrode rod ( s ) to the length dictated by MIN switchpoint.
High-water level switchpoint exceeded - No function Fault.
Replace electrode rod ( s ) and cut new rods to the length dictated by the switchpoint LW.
Level below switchpoint “ Water level - pump OFF ” Pump LED is not illuminated.
Remedy, Cut electrode rod to the length dictated by the switchpoint HW.
High-level ” switchpoint exceeded - no indication.
A high-level alarm is simulated for switchpoint 1.
Switchpoint = pm. DiscreteUniform.
A low-level alarm is simulated for switchpoint 4.
Switchpoint 4, 20 % The level controller features the following factory set default values.
Cut electrode rod ( s ) to the length dictated by the switchpoint LW.
Switchpoint 2 marks the upper limit of the proportional band for the level controller NRR 2-40.
The last digit in the line is selected and remains “ 0 ” for our example switchpoint MAX 70.
Level above switchpoint “ Pump OFF ”.
Time delay elapsed, LED 3 permantently illuminated, relay 3 energized Switchpoint 3 reached.
During operation, Switchpoint “ MIN water level ” exceeed, MIN LED illuminated green.
Time delay elapsed, LED 4 permanently illuminated, relay 4 de-energized Switchpoint 4 reached.
MIN 1 and MIN 2 alarm ( if 2 electrode rods are connected ) Water level below MIN 1 switchpoint.
High-level alarm, low-level alarm, pump ON, pump OFF with one switchpoint each.
