Examples of 't-handle' in a sentence
Meaning of "t-handle"
T-handle is a verb used to describe the action of gripping or turning something with a handle shaped like the letter T
How to use "t-handle" in a sentence
Basic
Advanced
t-handle
The T-Handle lock is most commonly used on metal garage doors.
It is light and can be easily transported with the provided T-handle.
Turn the drain T-handle counterclockwise to open.
Securely tighten the upper blade clamp screw using the T-handle hex key.
That little T-handle down on the console there.
Set the key position by dragging the T-handle or entering a value.
Turn the T-handle hex key and remove the screw.
Position blade and tighten the blade clamp screw securely using the T-handle hex key.
The T-handle provides more pressure without hurting your hand.
Such an adjustable width T-handle is shown in Fig.
Insert a T-handle hex key into the screw inside the chuck.
In the State of Massachusetts the gas cock must be a T-handle type.
Pull out on the T-handle located on the side of the pivot bracket.
Download the complete list of Spare parts available for T-handle.
Insert the T-handle into the top cylinder of the exposed pump rod.
See also
You can make your own homemade T-Handle.
Therefore an adjustable width T-handle is preferably provided as an option for the snow scooter.
T-handle pops out when unlocked.
The crew pulled and twisted the T-handle which discharged both fire extinguishers into the 2 engine.
If using a ball valve, it shall be a T-handle type.
A T-handle manual gas valve MUST be installed in the gas supply line to your range.
Slide lock washer and thread on T-Handle onto carriage bolt, turning to tighten.
Fit the small loop over the T-handle.
The inserter 60 preferably includes a T-handle for spacer control and positioning.
The T-handle is spring-loaded, so you will feel some resistance when pulling it out.
At the other end, there will be a T-handle head or a hex head.
A T-handle is more compact.
The square head fits into a T-handle that 's used to turn it the extractor.
Insert the screws for the first gib, turning them with the T-handle wrench.
Tube as the T-handle is turned.
When using ball type gas shut-off valves, they shall be the T-handle type.
Tighten the screws with the T-handle Torx driver T30 found in the assembly kit.
When using ball type gas shut-off valves, they must be the T-handle type.
T-handle just in case.
Tighten set screws with T-handle wrench.
Again, the T-handle of the trephine allows the surgeon to rotate the trephine 165.
Stainless Steel T-Handle.
Most cordless drills feature a T-handle which is, unsurprisingly, shaped like the letter ‘ T '!
Fig . 12 is a side view of an inserter with attached T-handle and emitter.
Specifically, the surgeon turns the T-handle torque wrench 520 until it clicks.
When using ball-type gas shut-off valves, they shall be T-handle type.
Pull that, uh, That little T-handle down on the console there.
When using bell-type gas shut-off valves, they shell be T-handle type.
I built the t-handle.
Create your own review for Aluminium small 16-point adjustable Quick Release T-Handle.
When using ball-type gas shut-off valves, the t-handle type shall be used.
Create your own review for Aluminium medium 16-point adjustable Quick Release T-Handle.
Tighten the screw of the tool holder with the included 4.0 mm T-handle hex key.
When using ball-type gas shut-off valves, you must use the T-handle type.
Hexagonal Allen key 2mm with T-handle.
