Examples of 'tailpiece' in a sentence
Meaning of "tailpiece"
A tailpiece is a part of a musical instrument, typically a stringed instrument, that anchors the strings at the base and controls their tension and length
Show more definitions
- An appendage or appendix.
- An element, often triangular, to which the strings of a violin, guitar, etc. are attached at the lower end of an instrument.
- A short joist between a header and a wall.
- The part of a telescope containing the adjusting device for the eyepiece, etc.
How to use "tailpiece" in a sentence
Basic
Advanced
tailpiece
Secure the drain tailpiece to the trap.
The tailpiece and bring them up and.
It has a floating bridge and a metal tailpiece.
It has a tailpiece to actuate the lock mechanism.
A mechanical arm for connections to an advancing tailpiece.
Insert the drain tailpiece into the trap.
The tailpiece is also made of ebony.
The adapter installs directly to the sink tailpiece.
With tailpiece without rubber seals.
Place the newly assembled unit under the tailpiece.
A tailpiece that can change pitch.
The pieces on the tailpiece also look like teeth.
They are grouped at a rear part of the projectile to form a tailpiece.
The stopbar tailpiece is meant to be adjusted for string tension.
The projectile is thus on a trajectory stabilised by its fin tailpiece.
See also
Extended ebony tailpiece and heightadjustable ebony piezo bridge.
Any of these sequences described herein can be included in a tailpiece.
The rear tailpiece was dropped in place of a painted rear fender.
A special thin film on the tailpiece has the answer.
The tailpiece was now black instead of dark blue.
The bevelled fingerboard and the tailpiece were decorated with marquetry.
We decided to opt for the second solution for the tailpiece.
The thin tailpiece should not be used as a clip since it may deform.
The strings are routed over it before ending on the body or on a tailpiece.
This is therefore very much a tailpiece that should have its place.
The chemical ligation process can optionally include addition of a tailpiece.
For copper and plastic piping with tailpiece without rubber seal.
The end loop of the belt is carried by a pulley of the advancing tailpiece.
Drawing the bow across the tailpiece creates a very quiet resonant sound.
Is you did not slip the trap nut and washer onto the tailpiece.
Raising the tailpiece slightly can reduce the pressure and the problem.
There have also been several reports of this tailpiece failing at the hinge.
Because the tailpiece is large and heavy this sound is general of a quite low pitch.
However this one has a normal bridge and not these tailpiece bridges.
Tailpiece X must be inserted in the horizontal slot in order to change your combination.
The carrier idler assemblies must be installed through the frame of the tailpiece.
Your chinrest is attached just to the left of the tailpiece by a special metal bracket.
The initial pipe that leads from the strainer to the trap is termed the tailpiece.
Make sure that tailpiece Y is engaged into the horizontal cutout of the inside thumbturn assembly.
It has a Bigsby vibrato tailpiece.
Shorten the combination change tailpiece X according to your door thickness.
It has the recognizable Dean headstock and the V shaped tailpiece.
In addition, a tailpiece and sink trap will be needed.
Gibraltar ii bridge, quick change ii tailpiece.
The bow thruster tailpiece has long-term lubrication.
Union nut, sealing and red bronze soldering tailpiece.
If your tailpiece comes off, bring the instrument in to your luthier.
Insert the taillight, holding the tab under the tailpiece.
Similary, the tailpiece of the invention can encode or not encode information.
In other words, they wish to test you as well as the tailpiece.
