Examples of 'timer t' in a sentence
Meaning of "timer t"
timer t: This phrase is often used in technical contexts to refer to a specific time or duration, especially when discussing schedules, deadlines, or operations that are time-sensitive
How to use "timer t" in a sentence
Basic
Advanced
timer t
The timer t thus represents the time during which a subtitling page is consulted by the user.
The processing after the timer T expires is described hereafter.
A timer T is defined and is valid for all the dialogs of a session is set up.
The value of the initiated timer T represents a minimum response time.
The timer T measures the time by counting the number of clock signals.
The closing of this contact C activates the arming of the timer T for a time t.
Preferably, the time counted by the timer T corresponds to the last determined inter-arrival time TDIFF.
The authentication control unit 50 includes the timer t.
In both cases the timer t is subsequently started in a step 63.
Anytime that the counter is greater than 0, a timer t is running.
Stop timer t and reset to 0.
In a first step S1 before the beginning of the treatment, a timer t is resetted.
A timer T is also connected to an input of a third management unit 57.
When this message is received, timer T 0 is deactivated.
That is, the timer T is started when the data packet is transmitted in step ST91.
See also
At a step S13, it is determined if the timer T value indicates a reception time.
A timer T 0 is associated with bitmap block BMB 0, associated with PDUs numbered 0 to 7.
At the step S13, it is determined if the timer T value indicates the reception period.
The peripheral cell search control section 15 sets a cell search execution cycle At in a timer T ( ST2 ).
Then, the timer T is cleared to zero.
In the latter case, the actuator 26 is started before the timer T 1 has run out.
At a step S16, the timer T is started to perform a counting operation.
Finally in step 320, the system inactivity timer T is set to the default value.
The internal timer T starts counting the time in decrements ( step S2 ).
Timer T 0 is again reactivated during transmission of PDU ( 3 ).
With a start signal, a timer T is initialized at a step S11.
When the timer T does not time over, the processing routine is returned to step S403.
To be exact, the timer t is built in the control part 51.
You'll also be interested in:
Examples of using Timer
Show more
The timer does not control the explosion
The auto off timer can be used
The timer can be used any time
