Examples of 'tip speed' in a sentence
Meaning of "tip speed"
tip speed ~ the speed at the tip or outer edge of a rotating object
How to use "tip speed" in a sentence
Basic
Advanced
tip speed
Tip speed is a function of the speed of rotation.
Method of controlling the tip speed ratio of wind turbine blades.
This tip speed was maintained until no granular material was evidenced in composition.
The product of impact crushers is affected dramatically by the tip speed of the hammers.
Rated tip speed ratio.
The pressure a centrifugal compressor can develop depends on the tip speed of the impeller.
The tip speed should be maintained until no granular material is evidenced in the composition.
This is where the Tip Speed Ratio comes in.
Tip speed is thus a function of the rotor diameter and the rotation rate.
Figure 6 presents the test results as a function of the mixer tip speed.
Tip speed means the tangential velocity of the refrigerant leaving the impeller.
In the context of the present invention, tip speed is the parameter most preferred.
Tip speed is thus a function of the rotor diameter and the rotational frequency.
On the other hand, too high of a tip speed increases the production of undesirable fines.
As tip speed ratio decreases, the noise generated increases.
See also
For instance, in part load operation a tip speed ratio of the rotor blades is calculated.
The tip speed is the speed by which the beads 9 are being agitated.
Also as shown by the previous equations, the frequency of operation also impacts tip speed.
And the tip speed ratio and the blade pitch angle can be.
The disperser speed represents a tip speed of about 13 meters / second.
The operating tip speed for the tail rotor blades was selected based upon noise considerations.
The apparatus is preferably used with tip speed of the blades of 30 m / s.
A tip speed in excess of 10 meters per second provides satisfactory conversion rates.
Particularly beneficial results are obtained with a tip speed in excess of 10 meters / second.
The tip speed of the mixer was approximately 25 m / s.
The following computations are carried out imposing a tip speed of 75 m / s on all blades.
The granulator 's impeller tip speed can also affect the particle size of the granules.
He researched propeller shapes and materials that could withstand tip speed up to Mach 1.35.
The tip speed of the mixer was approximately 25m/s.
The flow of nitrogen gas was adjusted to maintain a tip speed in excess of 10 meters / second.
The tip speed of a blade in operation is for instance 80 m / s.
Also, the rotor 's solidity and tip speed can vary from row to row.
The tip speed of the impeller was about 6.2 m / s in both cases.
The hammers rotate inside the sieve with a tip speed that is for example 65 m / sec.
This means a tip speed ( 5 - 7 m / s ) at which the wear of the blades is still insignificant.
Computation of rotor performance over Tip speed ratio ( tip speed ratio ) range.
The tip speed of the rotor is preferably set at between about 15 and about 25 m / sec.
The rotational speed of the mixers corresponded to a tip speed of 2.8 m / s.
The slurry was milled 18 h with a tip speed of 5.8 m / s affording a near transparent suspension.
Once wetted, the stir rate was increased to a peripheral tip speed of about 20 m / sec.
Substituting the worst case tip speed ratio into the above equation, w = 4*v/Rmax.
The tip speed ratio ( TSR ) is defined as.
The units were usually operated at a mixer tip speed of 8-30 meters per second.
