Examples of 'tool base' in a sentence
Meaning of "tool base"
tool base: Refers to a stable and supportive surface or structure on which tools can be placed or mounted for easy access and organization
How to use "tool base" in a sentence
Basic
Advanced
tool base
Install the tool base on the tool.
They may cause cracks in the tool base.
Remove the tool base from the tool.
Place the templet guide on the tool base.
The right side of the tool base is graduated in inches.
Loosen the two screws on the tool base.
Set the tool base on the workpiece to be cut without the.
Graduation on right side of tool base.
Always hold the tool base flush with the workpiece.
The blade is exposed under the tool base.
The tool base will open at a stroke by the spring force.
Equally over each side of the tool base.
Move the tool base until the desired depth of cut is obtained.
Theoretical coordinates of the tool base.
Open the cover while holding the tool base with a hand as shown in the figure.
See also
Then tighten the bolt to secure the tool base.
Carry the tool by holding the tool base as shown in the figure.
Strong adhesion of the layer to the lapping tool base.
Align the centre marking on the tool base with the marking line as.
Insert this screw through a screw hole in the tool base.
Install the vacuum head on the tool base using the two screws.
Open the blade case while holding the tool base.
Failure to hold the tool base flush with the workpiece may cause blade breakage.
Plywood must be at least as deep as the tool base being mounted.
The polished tool base was placed in a CVD reactor under the following conditions.
Carry the tool by holding both sides of the tool base.
Install the trimmer guide on the tool base with the clamp screw A.
The position of the bit must be higher than the tool base.
Install the trimmer guide on the tool base with the wing bolt B.
The belt hook may be used on either side of the tool base.
Hence, the tool base diameter is the effective diameter.
Then pull the dust box out of the tool base.
With the tool base tilted, you can make bevel cuts at any.
Loosen the wing nut and secure the tool base horizontally.
Then, tilt the tool base until it stops and secure the base with the lever.
Loosen the wing bolts and secure the tool base horizontally.
Do not smear the tool base carelessly with thinner, gasoline, oil or the like.
Screw the guide bars into the holes in the tool base.
Preferably, the surface área 2 b of the tool base support 2 consists of three essential segments.
The socket wrench is stored on the left side of the tool base.
Loosen the bolt on the back of the tool base with the hex wrench.
Align the tool with the biscuit marks using the markings on the tool base.
FIG . 1 is a view illustrating the tool base diameter on an exemplary workpiece.
Move the belt hook to the other side of the tool base.
The tool base 26 may include a passageway 46 therein which communicates with the inner vacuum chamber 34.
Then tighten the bolt to secure the tool base and the retainer.
An annular punch 7 is supported on an outer edge of the tool base.
Adjusting angle of tool base Fig . 2.
After adjusting, tighten the lever firmly to secure the tool base.
Build the technological foundation, such as the tool base for analytics.
You'll also be interested in:
Examples of using Base
Show more
Lock bowl onto base by turning clockwise
Base men by his endowments are made great
Hold match at base of desired surface burner
Examples of using Tool
Show more
The tool is intended for blowing debris
Have your power tool ser v iced by a
Tool operates erratically or appears to be losing power
