Examples of 'top dead' in a sentence
Meaning of "top dead"
top dead: A term used in mechanical engineering or automotive industry to refer to the position of an engine's piston when it is at its highest point during the combustion cycle
How to use "top dead" in a sentence
Basic
Advanced
top dead
Position all pistons at top dead center.
Top dead centre of a piston.
Piston has reached top dead center.
At top dead centre the contact pressure should not be excessive.
How to set top dead centre.
Rotate the pump shaft so the piston is in the top dead.
The fluctuating energy at top dead center is reduced.
Is the pressure prevailing in the casing when the piston is at top dead centre.
Static advance with respect to top dead centre crank angle degrees.
One goes on to the following cylinder and awaits the next top dead center.
Tritium can not penetrate the top dead layer of skin in humans or animals.
Stance the piston is positioned before the top dead centre.
Top dead center, by detecting the position of the crankshaft.
The piston is shown at the top dead centre.
If the detection of the top dead center is possible, efficiency is improved.
See also
When the piston comes up to the top dead center.
Next, combustion near the top dead center of the compression stroke is started.
Check valve clearance with the piston at top dead centre.
All things considered, setting an engine to top dead center is a relatively straightforward procedure.
Turn the crankshaft until the piston reaches top dead centre.
We started by rotating the crank to top dead center and disassembling the engine.
This valve is closed in the vicinity of the next top dead center.
It relates this opposed marker to the top dead center position of a further cylinder.
The piston is also shown in a position below the top dead centre.
The revolutionary technology of firing after top dead center validated by recent laboratory tests.
Chamber only a fraction of a second before the cylinder reaches the top dead centre.
Static advance with respect to Top Dead Center crank angle degrees.
The piston is drawn in a location a certain distance away from the top dead centre.
Figure 7 shows the piston at top dead center position just after ignition.
This may for example occur at or near top dead centre.
This movement toward top dead centre is represented by the arrow bearing the reference 32.
Each yarn of the first layer has a top dead center longitude.
Top dead center of smaller cylinderb =.
The engine in the invention uses a device for stopping the piston at top dead centre.
Next, the combustion starts near top dead center of the compression stroke.
The yarn has advanced slightly while the needle has reached its top dead point.
Thus, the compression top dead center can be detected for the front bank FB.
Rotate the engine until the piston number one reaches the top dead center point.
As the piston 6 ' travels towards top dead centre, the fuel mixture is ignited.
The piston PS continues to move toward the top dead center.
The top dead center longitude remains within 1.5 yarn diameters of the top plane.
The easiest way is to modify the installed ignition to Top Dead Centre.
At top dead centre the exhaust fluids have all substantially been expelled from the cylinder 12 '.
At this point, the piston is in top dead center.
The top dead center tooth 43a is the third closest tooth from the crank angle sensor 3.
If there are no numbers, the largest notch means top dead centre.
The top dead center point is the fully-loaded position of the closing spring 114.
Advantageously, the pressure pa is measured at each top dead centre point.
The pipe is marked along top dead centre ( TDC ) of the extrusion line ( if known ).
Moreover, the piston is at a position away from top dead center.
