Examples of 'total elongation' in a sentence
Meaning of "total elongation"
Total elongation refers to the overall increase in length of a material under tensile stress. It is commonly used in material science and engineering to measure the deformation of a material when subjected to a force
How to use "total elongation" in a sentence
Basic
Advanced
total elongation
The total elongation at maximum tensile load.
Proof stress total elongation.
The total elongation values seem to be almost independent of the ageing cycle.
The workability was evaluated using the measured value of the total elongation.
Whereby the total elongation and uniform elongation were determined.
Increasing the volume fraction of martensite increases the strength and decreases the total elongation.
The average value of total elongation of two samples was determined.
The concentric bars are equipped with stop ends which limit the bar total elongation.
The total elongation was measured using strain gauges distributed over the width of the specimen.
Determination of non-proportional total elongation.
Total elongation Et.
Determination of proof stress non-proportional elongation and of total elongation.
Tables 5 and 6 show the uniform and total elongation results of plant trial testing.
Then, the total elongation of the test specimen in the sheet length direction was evaluated.
A tensile test was carried out ; and thereby, the total elongation value was measured.
See also
Iv Total elongation at maximum tensile load;.
Preferably, the second material has a higher total elongation than the first material.
The measured value is compared with a distance before the tensile test, to calculate total elongation.
The percentage total elongation at maximum load is calculated by the following formula, EPMATHMARKEREP.
UTS indicates tensile strength, YS indicates yield strength and E1 indicates total elongation.
Preferably, the total elongation ranges from about 2 percent to 4 percent.
Figure 5 shows a plot of hole-expansion ratio against total elongation JIS No.
Preferably, the total elongation of the cord ranges from 2 percent to 4 percent.
The yield strength was found by the 0.7 % total elongation method.
The total elongation is more preferably 14 % or more.
The processing module 23 simultaneously records the total elongation value V H supplied by the first sensor 16.
The total elongation is measured through the tensile test defined in JISZ2201.
At ( % ) is the percentage total elongation at fracture.
Total Elongation at Fracture min. %.
The yield stress was found by the 0.7 % total elongation method.
Preferably, the second material has a total elongation greater than or equal to 17 %.
The steel sheet according to claim 1, wherein a total elongation is greater than 14 %.
Preferably, the hot dip galvanised steel strip has a total elongation of at least 18 %.
The operational elongations, corresponding here to the total elongation A t, is high, on the order of 6 %.
In the tensile test, the tensile strength ( TS ) and the total elongation ( EL ) were measured.
You'll also be interested in:
Examples of using Total
Show more
What you did was total and utter betrayal
Total separation between product and propellant
As percentage of total number of cleared cases of arrest
Examples of using Elongation
Show more
Elongation of the parietal and occipital regions
In order to terminate elongation dephosphorylation must occur
Elongation at half the knot breaking load
