Examples of 'total impedance' in a sentence
Meaning of "total impedance"
total impedance: The combined resistance to the flow of electric current in a circuit, including both resistance and reactance, expressed usually in ohms
How to use "total impedance" in a sentence
Basic
Advanced
total impedance
The total impedance is at the maximum.
Notice that different combinations of speaker impedances can equal the same total impedance load.
How to calculate the total impedance for parallel connections.
Since total current is minimum, in this state the total impedance is maximum.
Keep the total impedance below the maximum recommended in the.
Average contributions of these components to the total impedance are also provided in Fig.
Whose total impedance ranges between 8 ohms and.
When connecting the speakers together, the manner of connecting them affects the total impedance.
In this case the total impedance has to be divided by two once more.
When connecting several speakers, make sure that the total impedance does not fall below 4 Ω.
This Illustration shows the total impedance loads of various combinations of speakers connected in parallel.
When connecting several speakers, make sure that the total impedance will not fall below 4 Ω.
Ensure that the total impedance load of subwoofer is not lower than 1 ohm.
Only connect speakers or speaker systems of a total impedance of at least 4 Ω.
Ensure that the total impedance load of each speaker is not lower than 2 ohms.
See also
Attention, Take care not to use speaker cabinets with a total impedance lower than 8Ω.
For example, the total impedance may be calculated from the voltage and current values.
However, those same 2-ohm speakers connected in parallel would have a total impedance of only 4 ohms.
EN Connect a speaker with a total impedance of at least 4 ohms per channel.
The total impedance of the speakers connected must be 4 Ω as a minimum.
What is the formula for total impedance in a RLC circuit?
The total impedance of the speakers must not fall below 4 Ω.
Connect a speaker or a speaker group with a total impedance of 4 Ω or 8 Ω to the terminals 17.
The minimum total impedance of both Subwoofer must be higher than 1 Ohm.
Or 4Ω speakers or speaker groups with a total impedance of at least 4Ω fig.
ZT = total impedance per phase of the installation upstream of the fault location ( in Ω ).
LOUDSPEAKER CONNECTIONS - The total impedance must not be lower than 2 ohms.
The total impedance Z is obtained through following Equation ( 1 ).
For two 4 ohm speakers, the total impedance would be 2 ohms.
A pair of parallel-connected 8-ohm speakers have a total impedance of 4 ohms.
Please note that the total impedance is not lower than 1 Ohm per channel.
The loudspeaker total impedance shall not be lower than 4 Ω.
For each output, the total impedance of the speakers must not fall below 4 Ω.
Furthermore, the total impedance must be at least 4 Ω.
Connect a speaker group with a total impedance of 4 Ω as a minimum to the connection strip “ 4 Ω ” 15.
According to the total impedance connect 4 Ω and 8 Ω speakers to the screw terminals 22.
You'll also be interested in:
Examples of using Total
Show more
What you did was total and utter betrayal
Total separation between product and propellant
As percentage of total number of cleared cases of arrest
Examples of using Impedance
Show more
Speaker impedance ratings are less than precise
You can set the speaker impedance
Check the impedance of the connected speakers
