Examples of 'transistor t' in a sentence
Meaning of "transistor t"
Transistor t: A semiconductor device that amplifies or switches electronic signals, commonly used in electronic devices and circuitry
How to use "transistor t" in a sentence
Basic
Advanced
transistor t
This transistor T low is controlled by a signal drvl generated by the power control circuit.
This device controls a power transistor T connected to a power circuit.
The transistor T could be replaced by a resistor.
Resistor chain Ri is controlled by transistor T which can activate the shock detector.
The transistor T is in the off state.
A first curve A provides the current in the transistor T of a selected cell.
Also the transistor T could be replaced by any other switching device.
Output terminal Vout is connected to the base of transistor T via an avalanche diode Z.
The transistor T is controlled through the output from the VCO.
The gate of the distributed transistor T is formed by the polysilicon plate.
This results in a rise of the gate voltage of transistor T i, j.
The emitter of the transistor T is connected to ground.
This translates as a sufficient rise of the gate voltage of transistor T i, j.
The channel of the transistor T can be completely depleted.
A control and regulation circuit 2 is connected to a control electrode of the transistor T 1.
See also
The source metallization connected to the base B of transistor T is designated by this reference.
The transistor T 3 operates as a switch controlled by a voltage applied to its base.
The means for temporarily cutting off motor M power supply comprise a transistor T controlled by an oscillator O.
The zeroing signal controls a transistor T which is connected between the capacitor C and ground.
Due to this impedance decrease, the current injection in amplifying transistor T 3 is improved.
Amplifying transistor T 3 is traversed by the signal or part of the signal emitted by photodetector 1.
Volts on the gate of the distributed transistor T of the quadripole, it is off ;.
The second transistor T 2 is subjected to a specific biasing for avoiding it becoming saturated.
This causes an increase in the output current at the drain of the transistor T 3.
The transistor T 2 is commanded to close and can be used to pass the charge current.
This current is imposed by a current generator formed by a transistor T 4 common to several pixels.
A partial programming of the transistor T 1 is performed and its programming level is raised accordingly.
The output of the current pulse generation device is at the drain of the transistor T 3.
The gate of the transistor T 3 is connected to a direct current power supply producing a polarization voltage.
During this phase, in one preferred embodiment, the transistor T works in a linear mode.
Transistor T remains saturated until the end of the positive halfwave, which maintains switch 5 off.
By limiting the impedance on the collector of the second main input transistor T 2, and.
The gate-source voltage seen by the transistor T 5 is thus overall higher over the frame time.
Thus, the transistor is driven in dynamic mode by the first main input transistor T 1.
The drain of the transistor T 8 is connected to ground.
Within the substrate, alongside the buried layer, is implanted a bipolar transistor T in a conventional manner.
The emitter of this transistor T 4 is connected to earth.
Since its resistance increases, the voltage across the terminals of the transistor T 1 increases.
It is then the first transistor T 1 that is turned on.
It is also linked to a current source through a transistor T 6.
It is then the second transistor T 2 that is turned on.
Its source is connected to the drain of transistor T 6.
This circuit 8 consists of a transistor T controlled to be conducting.
Bipolar transistor T 1 has an operating mode as described hereunder.
The voltage regulator includes a voltage regulator circuit including a ballast or pass transistor T 1 and a differential amplifier.
The over-current in transistor T is more difficult to assess.
Several transistors are connected in parallel to the main transistor T 1.
The gate and the drain of transistor T 2 i are interconnected.
Small signal current from the emitter of transistor T 2.
In another embodiment, the transistor T is of the bipolar type.
You'll also be interested in:
Examples of using Transistor
Show more
Do not perform transistor measurements on live circuits
Overcurrent at the brake chopper brake transistor
It only indicates if the transistor is operating or not
