Examples of 'transmitter control' in a sentence
Meaning of "transmitter control"
The term 'transmitter control' refers to the regulation or management of a device responsible for sending signals, data, or information to other devices or systems, often in the context of telecommunications, electronics, or remote operations
How to use "transmitter control" in a sentence
Basic
Advanced
transmitter control
Transmitter control panel for command post.
Remote terminal transmitter control data.
See the Transmitter Control Identification section for more details about the differences between modes.
Make sure control surfaces correctly respond to transmitter control before flying.
Move the transmitter control sticks.
I have located John Brennick in the transmitter control room.
Closed loop transmitter control for power amplifier in an eas system.
Phone direct control with transmission or transmitter control with smart phone.
Move the transmitter control sticks and switches to the desired Preset failsafe position.
This signal is used in conjunction with the transmitter control circuits discussed below.
Transmitter control layout for MODE 2 radio.
Ready for transmitter control.
Ultrasonic detector, detection method for liquid media and ultrasonic transmitter control method.
Model should respond to all transmitter control inputs while the trainer switch is held.
Find him . I have located John Brennick in the transmitter control room.
See also
To drop the tow, operate the transmitter control which opens the tow release mechanism.
DSP 120 not only processes communication signals, but also provides for receiver and transmitter control.
Heading Gain is only active when the transmitter control stick is near center.
DXe Transmitter Control ( RTF ) Replace the transmitter batteries when the transmitter begins to beep comtinuously.
Eddie, this is the power transmitter control.
The transmitter control 65 is now designed to control the gain of the amplifiers.
Yeah. Eddie, this is the power transmitter control.
Hand-held transmitter control elements.
CENTER Servo centre in μs If active ( highlighted ), according to transmitter control position.
The transmitter 12 is controlled by a transmitter control circuit 16, which is controlled by a controller 16.
Parallel Remote Control - Dedicated DB -25 type connectors provide standard interfacing for transmitter control system connections.
AN/ARC-5 transmitter control boxes contain no Morse key.
Signals EPMATHMARKEREP and EPMATHMARKEREP are also generated by the transmitter control logic circuitry 2516.
TRANSMITTER MODE CHANGE Mode 2 is the default transmitter control mode for the iX12.
You'll also be interested in:
Examples of using Transmitter
Show more
Never operate the transmitter in places where it is
Transmitter with adhesive tape for affixing
Carefully place the transmitter on the antenna
