Examples of 'transmitter should' in a sentence
Meaning of "transmitter should"
transmitter should: This phrase might refer to an object or device that is responsible for transmitting signals or messages, and an expectation or necessity for it
How to use "transmitter should" in a sentence
Basic
Advanced
transmitter should
This transmitter should not be fitted in.
If that was the problem the transmitter should then work.
The transmitter should not be used near water.
The electrical connection to the transmitter should be used as originally supplied.
Each transmitter should have three neighbors minimum.
Please note that the helicopter and transmitter should have been previously bound.
The transmitter should always be near the antenna.
This will permit the station operator to quickly identify an offending transmitter should interference occur.
The speaker and transmitter should sync automatically.
When the batteries are installed correctly, the LED 's on the transmitter should glow brightly.
The transmitter should also feature a servo reverse facility.
It may however be desired that a transmitter should be able to control one receiver only.
The transmitter should not be depressurized if toxic substances are being used.
It is particularly important that the transmitter should be fully charged before each flying session.
The transmitter should be protected from water at all times.
See also
The control LED of the transmitter should be brightly lit.
The transmitter should only be opened in the following cases.
When completed the POWER LED on the Transmitter should illuminate continuously.
The transmitter should be small enough to carry in your pocket.
If my readings are correct, the transmitter should be down that road.
Every transmitter should be equipped with a testing and repair kit.
Assuming an hour-a-day usage, the battery life of the transmitter should exceed two years.
The remote transmitter should be placed in a dry shaded area.
The mobile station 420 may also decide which transmit weights the transmitter should use.
The belt and transmitter should not be put in the dryer.
A transmitter should use a measuring current below 1 mA.
At all other times, the transmitter should be in Standard mode.
The transmitter should be left in place for normal cleaning operations.
Which type of temperature transmitter should I use for which application?
The transmitter should be tested frequently to protect against undetected interference or fault.
The throttle path at the transmitter should be set to 100.
The transmitter should be placed close to the baby to transmit sounds by radio.
The later is to prefer as the transmitter should be protected somewhat, against low temperatures.
The transmitter should be positioned slightly lower than the headphone to ensure best performance.
It is, but my ultra-sonic transmitter should override the main computer 's commands.
The Transmitter should be checked for correct positioning and fit prior to tire replacement.
Spread-spectrum burst transmitter should be beyond Kradic 's capabilities.
The transmitter should approximately be pointed towards the connected IR-receiver.
In general the transmitter should not be operated below 4.8V.
The transmitter should be switched on for 30 seconds before the walk test is started.
The pressure transmitter should be mounted below the lowest level.
The transmitter should also have a distance of approx . 1 m from lateral walls.
The remote transmitter should operate normally after battery replacement.
The transmitter should be operational by mid1989, serving listeners in Ireland and the United Kingdom.
The power of the transmitter should be adjusted from the menu “ Settings ”.
The power transmitter should change its power signal between two levels.
The controller / transmitter should be mounted in the main living.
Now the transmitter should be paired with the receiver of ceiling fan 1.
The pressure transmitter should be protected from filling / emptying current and agitator surges when mounted.
The slave transmitter should be in Inhibit mode, if available.
You'll also be interested in:
Examples of using Transmitter
Show more
Never operate the transmitter in places where it is
Transmitter with adhesive tape for affixing
Carefully place the transmitter on the antenna
