Examples of 'trim ring' in a sentence
Meaning of "trim ring"
A trim ring is a decorative ring that is used to enhance the appearance of an object or to cover up any rough edges. It is commonly used in various applications, such as in car rims, light fixtures, or plumbing installations
How to use "trim ring" in a sentence
Basic
Advanced
trim ring
Housing and trim ring are stainless steel.
Ring outwards to remove the trim ring.
Attach the trim ring around the front panel.
Removing or attaching the trim ring.
Remove the trim ring and the mounting sleeve.
It becomes easy to remove the trim ring if the.
Push the trim ring to right and pull out the.
Extend top and bottom of the trim ring outwards.
Turn the jet trim ring counterclockwise to increase the flow.
Install the gauge tunnel and the trim ring.
Turn the jet trim ring clockwise to decrease the flow.
Push in the unit and install the outer trim ring on it.
Attach the trim ring with the grooved side facing down.
Releasing the front panel allows easier access to the trim ring.
It becomes easy to remove the trim ring if the front panel is released.
See also
Put the trim ring on the ceiling bracket and tighten the screws.
Chrome dual headlamp housing with chrome trim ring and headlight mount.
Remove the trim ring by firmly grasping one side and pulling.
Fix the front panel to the unit using screws after removing the trim ring.
A decorative hubcap and trim ring may be placed over the wheel.
Trim Ring for mounting on permanent ceiling can not be factory installed.
Lift the top of the outer trim ring then pull it out to remove it.
Install trim ring before attaching the overhead monitor to the metal installation bracket.
Extend top and bottom of the trim ring outwards to remove the trim ring.
The Allen head screws are real but not used to secure the trim ring.
Attach the trim ring with the side with a groove facing downward.
To the remaining snooze time, touch the metal trim ring.
Push the trim ring to left and pull out the left part.
Caution, do not remove the outer trim ring lamp assembly.
Push the trim ring downward and pull out the lower part.
Using a flathead screwdriver, unclip the metal trim ring from the lighting support.
Push the trim ring upward and pull out the upper part.
A gasket 88 comprised of resilient material extends between the channels and the trim ring.
Grasp the outer trim ring and twist until reaching the unlock position.
Before installing this product 1 Remove the trim ring.
Snap the trim ring into the plastic snap washers on the mounting screws.
Vacuum with a soft brush attachment or remove trim ring / baffle and clean with a soft cloth.
Place the trim ring over the ceiling bracket and snap it into place.
The Re-entrant housings will also fit a WB back box a trim ring included.
Trim ring Supplied with this unit.
Lamps feature a screw-in trim ring and bottom mount bracket.
Remove trim ring / baffle and vacuum inside of housing with a soft brush attachment.
Align notches on fan motor ( B ) canopy with raised areas on inside of trim ring C.
Center trim ring / baffle in ceiling opening.
Removing the unit 1 Remove the trim ring.
In this case, use the trim ring to conceal any gaps that may be present.
Removing the unit ( installed with the supplied mounting sleeve ) 1 Remove the trim ring.
Rubber bush Trim ring Before installing this product % Remove the holder.
By way of example, two identical grilles 60 can be positioned in the trim ring 50.
Attach trim ring / baffle to housing.
